[Xen-fr] problème démarrage rhel AS 3 domU sur Rhel AS 4 dom0

[tarek <moktari@xxxxxxxx>]

bonjour,
  
  voici les logs du démarrage d'une rhel as 3 qui est
en domU sur une rhel as 4 qui est en dom0..
je rencontre des soucis au niveau démarrage....
le boot se termine jusqu'au prompt du login/pass mais
avec des messages d'erreur..

le noyau de la rhel as 3 est 2.4.
Y a t-il un lien?

fichier de config de la VM:

kernel =
"/boot/vmlinux-syms-2.6.12.6-xen3_2.1_rhel4.1"
ramdisk = "/boot/initrd-2.6.12.6-xen3_2.1_rhel4.1.img"
memory = 256
name = "MonProjet"
nics=1
vif = [ 'mac=00:16:3E:25:1D:C7, bridge=xenbr0' ]
ip = "dhcp"
hostname = name
disk = [ 'file:/XenVM1/XenVM3.img,sda1,w' ]
root = '/dev/sda1 ro'
extra = "ro selinux=0 3"
netmask = "255.255.255.0"
gateway = "10.233.1.228"

==========================================
==========================================

[root@projet-xen ~]# xm create -c
/etc/xen/ConfigVM/MonProjet
 
Using config file "/etc/xen/ConfigVM/MonProjet".
Started domain MonProjet
Linux version 2.6.12.6-xen3_2.1_rhel4.1
(rread@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx) (gcc version
3.4.3 20050227 (Red Hat 3.4.3-22.1)) #1 SMP Sun Dec 4
10:45:29 PST 2005
BIOS-provided physical RAM map:
 Xen: 0000000000000000 - 0000000010000000 (usable)
0MB HIGHMEM available.
264MB LOWMEM available.
ACPI in unprivileged domain disabled
IRQ lockup detection disabled
Built 1 zonelists
Kernel command line: 
ip=dhcp:1.2.3.4:10.233.1.228:255.255.255.0:ProjetValeo:eth0:off
root=/dev/sda1 ro ro selinux=0 3
Initializing CPU#0
PID hash table entries: 2048 (order: 11, 32768 bytes)
Xen reported: 2392.024 MHz processor.
Dentry cache hash table entries: 65536 (order: 6,
262144 bytes)
Inode-cache hash table entries: 32768 (order: 5,
131072 bytes)
Software IO TLB disabled
vmalloc area: d1000000-fb7fe000, maxmem 34000000
Memory: 254976k/270336k available (2184k kernel code,
6916k reserved, 883k data, 184k init, 0k highmem)
Checking if this processor honours the WP bit even in
supervisor mode... Ok.
Security Framework v1.0.0 initialized
SELinux:  Disabled at boot.
Capability LSM initialized
Mount-cache hash table entries: 512
CPU: Trace cache: 12K uops, L1 D cache: 8K
CPU: L2 cache: 512K
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... disabled
Brought up 1 CPUs
NET: Registered protocol family 16
Brought up 1 CPUs
ACPI: Subsystem revision 20050309
ACPI: Interpreter disabled.
Linux Plug and Play Support v0.97 (c) Adam Belay
xen_mem: Initialising balloon driver.
usbcore: registered new driver usbfs
usbcore: registered new driver hub
PCI: Using ACPI for IRQ routing
PCI: If a device doesn't work, try "pci=routeirq".  If
it helps, post a report
PCI: System does not support PCI
PCI: System does not support PCI
Grant table initialized
IA-32 Microcode Update Driver: v1.14-xen
<tigran@xxxxxxxxxxx>
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 4096
bytes)
Initializing Cryptographic API
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
PNP: No PS/2 controller found. Probing ports directly.
i8042.c: No controller found.
io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered
RAMDISK driver initialized: 16 RAM disks of 8192K size
1024 blocksize
Xen virtual console successfully installed as tty1
Event-channel device installed.
netfront: Initialising virtual ethernet driver.
Uniform Multi-Platform E-IDE driver Revision:
7.00alpha2
ide: Assuming 50MHz system bus speed for PIO modes;
override with idebus=xx
Registering block device major 8
ide-floppy driver 0.99.newide
mice: PS/2 mouse device common for all mice
NET: Registered protocol family 2
IP: routing cache hash table of 2048 buckets, 16Kbytes
TCP established hash table entries: 16384 (order: 5,
131072 bytes)
TCP bind hash table entries: 16384 (order: 5, 131072
bytes)
TCP: Hash tables configured (established 16384 bind
16384)
NET: Registered protocol family 8
NET: Registered protocol family 20
EXT2-fs warning (device sda1): ext2_fill_super:
mounting ext3 filesystem as ext2

VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 184k freed
EXT2-fs error (device sda1): ext2_check_page: bad
entry in directory #991908: unaligned directory entry
- offset=0, inode=3686552232, rec_len=6638,
name_len=15
INIT: version 2.85 booting
                Welcome to Red Hat Enterprise Linux AS
                Press 'I' to enter interactive
startup.
Configuration des paramètres du noyau : [  OK  ]
Configuraton de l'horloge  (localtime) : lun déc 26
19:09:05 CET 2005 [  OK  ]
Configuration du nom d'hôte projet-valeo: [  OK  ]
Montage du système de fichiers USB : mount : type fs
usbdevfs non pris en charge par le kernel
[ÃCHOUÃ]
grep: /proc/bus/usb/drivers: No such file or directory
Initialisation de l'interface USB HID : modprobe:
Can't open dependencies file
/lib/modules/2.6.12.6-xen3_2.1_rhel4.1/modules.dep (No
such file or directory)
[ÃCHOUÃ]
Initialisation du clavier USB : modprobe: Can't open
dependencies file
/lib/modules/2.6.12.6-xen3_2.1_rhel4.1/modules.dep (No
such file or directory)
[ÃCHOUÃ]
Initialisation de la souris USB : modprobe: Can't open
dependencies file
/lib/modules/2.6.12.6-xen3_2.1_rhel4.1/modules.dep (No
such file or directory)
[ÃCHOUÃ]
Vérification du système de fichiers racine :
/dev/sda1: clean, 154599/1200576 files, 764175/2400863
blocks
[/sbin/fsck.ext3 (1) -- /] fsck.ext3 -a /dev/sda1 
[  OK  ]
Remontage du système de fichiers racine en mode
lecture-écriture : [  OK  ]
Activation des partitions swap : [  OK  ]
Recherche des dépendances de modules : depmod:
QM_MODULES: Function not implemented

[ÃCHOUÃ]
Vérification des systèmes de fichiers
Checking all file systems.
[  OK  ]
Montage des systèmes de fichiers locaux : [  OK  ]
Activation des quotas des systèmes de fichiers locaux
: [  OK  ]
Activation de l'espace swap : [  OK  ]
modprobe: Can't open dependencies file
/lib/modules/2.6.12.6-xen3_2.1_rhel4.1/modules.dep (No
such file or directory)
                                                      
                                                      
       modprobe: QM_MODULES: Function not implemented

                           /sbin/mkkerneldoth: line
25: /boot/kernel.h: Aucun fichier ou répertoire de ce
type
INIT: Entering runlevel: 3
Entering non-interactive startup
Applying Intel IA32 Microcode update: [  OK  ]
Vérification du nouveau matériel [  OK  ]
Mise à jour de /etc/fstab [  OK  ]
Applying iptables firewall rules: modprobe: Can't open
dependencies file
/lib/modules/2.6.12.6-xen3_2.1_rhel4.1/modules.dep (No
such file or directory)
iptables-restore v1.2.8: iptables-restore: unable to
initializetable 'filter'

Error occured at line: 3
Try `iptables-restore -h' or 'iptables-restore --help'
for more information.
[ÃCHOUÃ]
Configuration des paramètres réseau : [  OK  ]
Activation de l'interface loopback : Cannot get driver
information: Operation not supported
arping: socket: Address family not supported by
protocol
Erreur, un autre hôte utilise déjà l'adresse
127.0.0.1.
[ÃCHOUÃ]
Activation de l'interface eth0 : Cannot get driver
information: Operation not supported

Définition des informations IP pour eth0. échoué.
[ÃCHOUÃ]
Démarrage de l'enregistreur chronologique du système
:  syslogd: cannot create /dev/log: Address family not
supported by protocol
[  OK  ]
Démarrage de l'enregistreur chronologique du noyau :[
 OK  ]
Démarrage de irqbalance :[  OK  ]
Démarrage de portmapper :[  OK  ]
Démarrage de NFS statd :[  OK  ]
Starting keytable:  Chargement de la configuration
clavier :[ÃCHOUÃ]
Chargement des polices du système
:/etc/rc3.d/S17keytable: line 26: /dev/tty0: Aucun
périphérique ou adresse
Couldnt get a file descriptor referring to the console
[  OK  ]
[ÃCHOUÃ]
Initialisation du générateur de nombres aléatoires
: [  OK  ]
Starting pcmcia:  [  OK  ]
Montage d'autres sytèmes de fichiers : [  OK  ]
Démarrage de automount : No Mountpoints Defined[  OK 
]
Démarrage de sshd :[  OK  ]
Démarrage de xinetd :[  OK  ]
Starting
MySQL...................................[ÃCHOUÃ]
Démarrage des services de souris de la console :gpm:
oops() invoked from gpn.c(132)
loadlut: is your kernel compiled with CONFIG_SELECTION
on?: Address family not supported by protocol
[ÃCHOUÃ]
Démarrage de httpd :httpd: Could not determine the
server's fully qualified domain name, using 127.0.0.1
for ServerName
[ÃCHOUÃ]
Démarrage de crond :[  OK  ]
Démarrage de xfs :[  OK  ]
Démarrage de atd :[  OK  ]
Démarrage du démon Red Hat Network :[  OK  ]
rhnsd[2481]: Red Hat Network Services Daemon starting
up.


merci...



        

        
                
___________________________________________________________________________ 
Nouveau : téléphonez moins cher avec Yahoo! Messenger ! Découvez les tarifs 
exceptionnels pour appeler la France et l'international.
Téléchargez sur http://fr.messenger.yahoo.com

_______________________________________________
Xen-fr mailing list
Xen-fr@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-fr