[PATCH net-next v2 08/10] netxen: use pskb_may_pull() to pull excess TX frags into the head

[Josef Bacik <josef@xxxxxxxxxxxxxx>]

netxen_nic_xmit_frame() pulls the frags that don't fit in a TX
descriptor into the head with __pskb_pull_tail().  It already checks the
result.  Switch to pskb_may_pull(), which takes the length the head
should end up with and checks it against the skb, so this driver no
longer calls __pskb_pull_tail() directly.

__pskb_pull_tail() also releases empty frags, even when there's nothing
to pull, so if the frags being pulled are all empty it still gets the
frag count under the limit.  pskb_may_pull() returns early in that case,
so follow it with skb_drop_empty_frags().

Assisted-by: LLM
Signed-off-by: Josef Bacik <josef@xxxxxxxxxxxxxx>
---
 drivers/net/ethernet/qlogic/netxen/netxen_nic_main.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/net/ethernet/qlogic/netxen/netxen_nic_main.c 
b/drivers/net/ethernet/qlogic/netxen/netxen_nic_main.c
index 67d9bf69f8f2..f5f89ed87d95 100644
--- a/drivers/net/ethernet/qlogic/netxen/netxen_nic_main.c
+++ b/drivers/net/ethernet/qlogic/netxen/netxen_nic_main.c
@@ -2045,7 +2045,8 @@ netxen_nic_xmit_frame(struct sk_buff *skb, struct 
net_device *netdev)
                        delta += skb_frag_size(frag);
                }
 
-               if (!__pskb_pull_tail(skb, delta))
+               if (!pskb_may_pull(skb, skb_headlen(skb) + delta) ||
+                   skb_drop_empty_frags(skb, GFP_ATOMIC))
                        goto drop_packet;
 
                frag_count = 1 + skb_shinfo(skb)->nr_frags;

-- 
2.55.0