[PATCH] xen/arm: scan CLIDR Ctype fields upwards when probing LLC

[Mykola Kvach <xakep.amatop@xxxxxxxxx>]

From: Mykola Kvach <mykola_kvach@xxxxxxxx>

get_llc_way_size() currently scans CLIDR_EL1 Ctype fields from the
highest level downwards and stops at the first unified cache it finds.

However, CLIDR_EL1 describes the cache hierarchy from Ctype1 upwards.
Arm ARM DDI 0487J.a, D19.2.27 says that once software has seen a
Ctype value of 0b000 while reading from Ctype1 upwards, no caches
manageable by the architected set/way maintenance instructions exist at
further-out levels, and the higher Ctype fields must be ignored.

The current reverse scan can therefore select a unified cache level from
a Ctype field above the first no-cache level. Such a field is not part of
the architecturally described CLIDR/CCSIDR cache hierarchy and should not
be used for selecting the CCSIDR level.

Scan Ctype fields from L1 upwards, stop at the first no-cache level, and
keep the outermost unified cache observed before that point.

This preserves the result for regular cache hierarchies, while avoiding
selection of an architecturally ignored Ctype field.

Fixes: f4985fce6f0b ("xen/arm: add initial support for LLC coloring on arm64")
Signed-off-by: Mykola Kvach <mykola_kvach@xxxxxxxx>
---
This patch follows the xen-devel discussion:
https://lists.xenproject.org/archives/html/xen-devel/2026-01/msg00345.html

In that thread, Michal noted that the reverse scan was a simplification
rather than an intentional requirement, and that changing the
implementation would be fine.

Testing performed:
- standalone synthetic CLIDR tests covered both regular and pathological
  Ctype sequences and showed that the forward scan ignores unified cache
  levels above the first Ctype == 0b000 while the reverse scan can pick
  them
- Renesas H3ULCB booted with llc-coloring=on
---
 xen/arch/arm/llc-coloring.c | 22 +++++++++++++++++-----
 1 file changed, 17 insertions(+), 5 deletions(-)

diff --git a/xen/arch/arm/llc-coloring.c b/xen/arch/arm/llc-coloring.c
index 6f78817c57..3783f4c824 100644
--- a/xen/arch/arm/llc-coloring.c
+++ b/xen/arch/arm/llc-coloring.c
@@ -22,21 +22,33 @@ unsigned int __init get_llc_way_size(void)
     register_t id_aa64mmfr2_el1 = READ_SYSREG(ID_AA64MMFR2_EL1);
     uint32_t ccsidr_numsets_shift = CCSIDR_NUMSETS_SHIFT;
     uint32_t ccsidr_numsets_mask = CCSIDR_NUMSETS_MASK;
-    unsigned int n, line_size, num_sets;
-
-    for ( n = CLIDR_CTYPEn_LEVELS; n != 0; n-- )
+    unsigned int n, line_size, num_sets, llc_level = 0;
+
+    /*
+     * CLIDR_EL1 Ctype fields are interpreted from Ctype1 upwards. Once a
+     * no-cache level is seen, higher Ctype fields are architecturally ignored
+     * for the CLIDR/CCSIDR set/way manageable cache hierarchy.
+     *
+     * Keep the outermost unified cache before that point.
+     */
+    for ( n = 1; n <= CLIDR_CTYPEn_LEVELS; n++ )
     {
         uint8_t ctype_n = (clidr_el1 >> CLIDR_CTYPEn_SHIFT(n)) &
                            CLIDR_CTYPEn_MASK;
 
+        if ( ctype_n == 0b000 )
+            break;
+
         /* Unified cache (see Arm ARM DDI 0487J.a D19.2.27) */
         if ( ctype_n == 0b100 )
-            break;
+            llc_level = n;
     }
 
-    if ( n == 0 )
+    if ( !llc_level )
         return 0;
 
+    n = llc_level;
+
     WRITE_SYSREG((n - 1) << CSSELR_LEVEL_SHIFT, CSSELR_EL1);
     isb();
 
-- 
2.43.0