[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [PATCH v2 5/8] xen/arm/gic: Allow routing/removing interrupt to running VMs
On 5/16/2024 6:03 PM, Henry Wang wrote: From: Vikram Garhwal <fnu.vikram@xxxxxxxxxx> Currently, routing/removing physical interrupts are only allowed at the domain creation/destroy time. For use cases such as dynamic device tree overlay adding/removing, the routing/removing of physical IRQ to running domains should be allowed. Removing the above-mentioned domain creation/dying check. Since this will introduce interrupt state unsync issues for cases when the interrupt is active or pending in the guest, therefore for these cases we simply reject the operation. Do it for both new and old vGIC implementations. Signed-off-by: Vikram Garhwal <fnu.vikram@xxxxxxxxxx> Signed-off-by: Stefano Stabellini <stefano.stabellini@xxxxxxxxxx> Signed-off-by: Henry Wang <xin.wang2@xxxxxxx> --- v2: - Reject the case where the IRQ is active or pending in guest. --- xen/arch/arm/gic-vgic.c | 8 ++++++-- xen/arch/arm/gic.c | 15 --------------- xen/arch/arm/vgic/vgic.c | 5 +++-- 3 files changed, 9 insertions(+), 19 deletions(-) diff --git a/xen/arch/arm/gic-vgic.c b/xen/arch/arm/gic-vgic.c index 56490dbc43..d1608415f8 100644 --- a/xen/arch/arm/gic-vgic.c +++ b/xen/arch/arm/gic-vgic.c @@ -444,14 +444,18 @@ int vgic_connect_hw_irq(struct domain *d, struct vcpu *v, unsigned int virq, { /* The VIRQ should not be already enabled by the guest */ if ( !p->desc && - !test_bit(GIC_IRQ_GUEST_ENABLED, &p->status) ) + !test_bit(GIC_IRQ_GUEST_ENABLED, &p->status) && + !test_bit(GIC_IRQ_GUEST_VISIBLE, &p->status) && + !test_bit(GIC_IRQ_GUEST_ACTIVE, &p->status) ) p->desc = desc; else ret = -EBUSY; } else { - if ( desc && p->desc != desc ) + if ( desc && p->desc != desc && + (test_bit(GIC_IRQ_GUEST_VISIBLE, &p->status) || + test_bit(GIC_IRQ_GUEST_ACTIVE, &p->status)) ) This should be + if ( (desc && p->desc != desc) || + test_bit(GIC_IRQ_GUEST_VISIBLE, &p->status) || + test_bit(GIC_IRQ_GUEST_ACTIVE, &p->status) ) @@ -887,7 +887,8 @@ int vgic_connect_hw_irq(struct domain *d, struct vcpu *vcpu, } else /* remove a mapped IRQ */ { - if ( desc && irq->hwintid != desc->irq ) + if ( desc && irq->hwintid != desc->irq && + (irq->active || irq->pending_latch) ) Same here, this should be + if ( (desc && irq->hwintid != desc->irq) || + irq->active || irq->pending_latch ) Kind regards, Henry
|
Lists.xenproject.org is hosted with RackSpace, monitoring our |