Re: [PATCH for-4.14 2/8] x86/hvm: don't force vCPU 0 for IRQ 0 when using fixed destination mode

[Roger Pau Monné <roger.pau@xxxxxxxxxx>]

On Thu, Jun 18, 2020 at 03:43:00PM +0200, Jan Beulich wrote:
> On 12.06.2020 17:56, Roger Pau Monne wrote:
> > When the IO APIC pin mapped to the ISA IRQ 0 has been configured to
> > use fixed delivery mode do not forcefully route interrupts to vCPU 0,
> > as the OS might have setup those interrupts to be injected to a
> > different vCPU, and injecting to vCPU 0 can cause the OS to miss such
> > interrupts or errors to happen due to unexpected vectors being
> > injected on vCPU 0.
> > 
> > In order to fix remove such handling altogether for fixed destination
> > mode pins and just inject them according to the data setup in the
> > IO-APIC entry.
> > 
> > Signed-off-by: Roger Pau Monné <roger.pau@xxxxxxxxxx>
> 
> Technically
> Reviewed-by: Jan Beulich <jbeulich@xxxxxxxx>
> 
> I wonder though why this was done in the first place - it very much
> feels like a workaround for certain guest behavior, and hence
> getting rid of it may mean a certain risk of regressions. Not a
> very good point in time to make risky changes ...

We can defer to after the release I guess, but I will still ask for
the changes to be backported.

What we currently do is broken, up to the point that FreeBSD cannot
use the PIT because it will likely route the interrupt to a vCPU != 0
in fixed mode, and then it will just get stuck because the vector is
delivered to vCPU 0 where it's not even configured.

Roger.