[Xen-devel] [TESTDAY] Test report

[Roman Shaposhnik <roman@xxxxxxxxxx>]

NOTE: this may or may not be a hair on fire problem, reporting it
anyway since I'd hate to pass on something that maybe a serious issue.
I haven't had time to debug this just yet -- so just reporting it here
pretty raw.

Software:
   Xen 4.13 RC2
   Linux kernel 4.19.5
Hardware:
   Supermicro E300
       https://www.supermicro.com/en/products/system/Mini-ITX/SYS-E300-8D.cfm
   Supermicro E100
       https://www.supermicro.com/en/products/system/Box_PC/SYS-E100-9S.cfm
   Supermicro E50
       https://www.supermicro.com/en/products/system/Box_PC/SYS-E50-9AP.cfm

Functionality tested: trying to boot Dom0
Comments: Xen boots completely and then seems like it either dies
right after saying
    Xen relinquishing a console
or Dom0 dies (without printing a single line of output)

FWIW, this started happening after upgrade to RC2. IOW, if I take my
previous RC1 binary and stick it into the very same setup --
everything boots fine.

The issue doesn't seem to be reproducible on Dell boxes (and in my
virtual QEmu setup) that I've got.

Thanks,
Roman.

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxxx
https://lists.xenproject.org/mailman/listinfo/xen-devel