Re: [Xen-devel] [PATCH v3 11/16] x86/mm: put HVM only code under CONFIG_HVM

["Jan Beulich" <JBeulich@xxxxxxxx>]

>>> On 04.09.18 at 18:15, <wei.liu2@xxxxxxxxxx> wrote:
> --- a/xen/arch/x86/mm/Makefile
> +++ b/xen/arch/x86/mm/Makefile
> @@ -1,15 +1,16 @@
>  subdir-y += shadow
> -subdir-y += hap
> +subdir-$(CONFIG_HVM) += hap
>  
> -obj-y += paging.o
> -obj-y += p2m.o p2m-pt.o p2m-ept.o p2m-pod.o
> -obj-y += altp2m.o
> +obj-$(CONFIG_HVM) += altp2m.o
>  obj-y += guest_walk_2.o
>  obj-y += guest_walk_3.o
>  obj-y += guest_walk_4.o
> +obj-y += mem_access.o

Despite it currently being always-on on x86, perhaps use
obj-$(CONFIG_MEM_ACCESS) as you touch it anyway?

With or without this
Acked-by: Jan Beulich <jbeulich@xxxxxxxx>
for the tiny bit of this patch where it's applicable.

Jan



_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxxx
https://lists.xenproject.org/mailman/listinfo/xen-devel