|
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [Xen-devel] [PATCH v17 17/19] osstest: remove the loader timeout from the install image
When the FreeBSD installer is booted on the godello{0/1} boxes it
receives spurious key strokes. This doesn't happen so far when booted
from disk, or with any other boxes.
In order to cope with this remove the loader timeout on the install
image. Note that failure to boot will still drop the loader into a
manual prompt.
Signed-off-by: Roger Pau Monné <roger.pau@xxxxxxxxxx>
---
ts-freebsd-build | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)
diff --git a/ts-freebsd-build b/ts-freebsd-build
index 54cb5902..5e7e1078 100755
--- a/ts-freebsd-build
+++ b/ts-freebsd-build
@@ -135,7 +135,7 @@ chmod 0600 etc/ssh/ssh_host_*_key
chmod 0644 etc/ssh/ssh_host_*_key.pub
# Setup serial console output for stage1
-printf "%s" "-h -S$bauds" >> boot.config
+printf "%s" "-hn -S$bauds" >> boot.config
cat << ENDBOOT >> boot/loader.conf
# Serial console configuration
boot_serial="YES"
@@ -143,6 +143,7 @@ comconsole_speed="$bauds"
console="comconsole"
boot_verbose="YES"
beastie_disable="YES"
+autoboot_delay="-1"
# mfs boot parameters
mfs_load="YES"
--
2.13.6 (Apple Git-96)
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxxx
https://lists.xenproject.org/mailman/listinfo/xen-devel
|
![]() |
Lists.xenproject.org is hosted with RackSpace, monitoring our |