Re: [Xen-devel] ARM64:Porting xen to new hardware

[Julien Grall <julien.grall@xxxxxxx>]

Hi,

On 09/25/2017 01:53 PM, bharat gohil wrote:
> Hello Andrii,
>
> I tried but no success.
> It looks, Xen is not running.
I am a bit confused... on one of the previous e-mail you posted log from 
Xen:
(XEN) *** Serial input -> DOM0 (type 'CTRL-a' three times to switch 
input to Xen)
(XEN) Freed 272kB init memory.

So unless you have a completely new setup, Xen is definitely running.
However, what may happen is the serial driver in Xen does not receive 
input characters.
One of the first test would be to check whether the driver effectively 
receive characters.
Cheers,

> Thanks,
> Bharat
>
> On Mon, Sep 25, 2017 at 5:45 PM, Andrii Anisov <andrii_anisov@xxxxxxxx 
> <mailto:andrii_anisov@xxxxxxxx>> wrote:
>     Hello Bharat,
>
>
>     On 25.09.17 11:42, bharat gohil wrote:
>
>         Hello Wilk,
>
>         I had try Ctrl+a three times and 'd' but no dump on the serial
>         console.
>
>     Its a way to switch to XEN debug console. In case you are using
>     minicom, you should press Ctrl+A six times, then you will see the
>     line like following:
>          (XEN) *** Serial input -> Xen (type 'CTRL-a' three times to
>     switch input to DOM0)
>
>     Then you can press 'h' for seeing installed key handlers.
>
>     But all of this requires XEN to be running somehow.
>
>     -- 
>
>     *Andrii Anisov*
>
>
>
>
>
> --
> Regards,
> Bharat Gohil
> Sr.Software Engineer
> bharat.gohil@xxxxxxxxxx <mailto:bharat.gohil@xxxxxxxxxx>
> +919427054633
--
Julien Grall

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
https://lists.xen.org/xen-devel