[Xen-devel] [PATCH 1/1] xen-blkback: stop blkback thread of every queue in xen_blkif_disconnect

[Annie Li <annie.li@xxxxxxxxxx>]

If there is inflight I/O in any non-last queue, blkback returns -EBUSY
directly, and never stops thread of remaining queue and processs them. When
removing vbd device with lots of disk I/O load, some queues with inflight
I/O still have blkback thread running even though the corresponding vbd
device or guest is gone.
And this could cause some problems, for example, if the backend device type
is file, some loop devices and blkback thread always lingers there forever
after guest is destroyed, and this causes failure of umounting repositories
unless rebooting the dom0. So stop all threads properly and return -EBUSY
if any queue has inflight I/O.

Signed-off-by: Annie Li <annie.li@xxxxxxxxxx>
Reviewed-by: Herbert van den Bergh <herbert.van.den.bergh@xxxxxxxxxx>
Reviewed-by: Bhavesh Davda <bhavesh.davda@xxxxxxxxxx>
Reviewed-by: Adnan Misherfi <adnan.misherfi@xxxxxxxxxx>
---
 drivers/block/xen-blkback/xenbus.c | 10 ++++++++--
 1 file changed, 8 insertions(+), 2 deletions(-)

diff --git a/drivers/block/xen-blkback/xenbus.c 
b/drivers/block/xen-blkback/xenbus.c
index 792da68..2adb859 100644
--- a/drivers/block/xen-blkback/xenbus.c
+++ b/drivers/block/xen-blkback/xenbus.c
@@ -244,6 +244,7 @@ static int xen_blkif_disconnect(struct xen_blkif *blkif)
 {
        struct pending_req *req, *n;
        unsigned int j, r;
+       bool busy = false;
 
        for (r = 0; r < blkif->nr_rings; r++) {
                struct xen_blkif_ring *ring = &blkif->rings[r];
@@ -261,8 +262,10 @@ static int xen_blkif_disconnect(struct xen_blkif *blkif)
                 * don't have any discard_io or other_io requests. So, checking
                 * for inflight IO is enough.
                 */
-               if (atomic_read(&ring->inflight) > 0)
-                       return -EBUSY;
+               if (atomic_read(&ring->inflight) > 0) {
+                       busy = true;
+                       continue;
+               }
 
                if (ring->irq) {
                        unbind_from_irqhandler(ring->irq, ring);
@@ -300,6 +303,9 @@ static int xen_blkif_disconnect(struct xen_blkif *blkif)
                WARN_ON(i != (XEN_BLKIF_REQS_PER_PAGE * blkif->nr_ring_pages));
                ring->active = false;
        }
+       if (busy)
+               return -EBUSY;
+
        blkif->nr_ring_pages = 0;
        /*
         * blkif->rings was allocated in connect_ring, so we should free it in
-- 
1.9.3


_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
https://lists.xen.org/xen-devel