[Xen-devel] [PATCH v11 02/34] ARM: GICv3: enable ITS on the host

[Andre Przywara <andre.przywara@xxxxxxx>]

Even though the ITS emulation is not yet in place, the host ITS already
gets initialized and Xen tries to map the host collections.
However for commands to be processed we need to *enable* the ITS, which
will be done in a later patch not yet merged.
So those MAPC commands are not processed and run into a timeout, leading
to a panic on machines which advertise an ITS in their DT.
This patch just enables the ITS (but not the LPIs on each redistributor),
to get those MAPC commands executed.
This patch was part of: "ARM: GICv3: enable ITS and LPIs on the host"
(patch v8 06/27 or v10 12/32, which was already acked by Stefano.

This fixes booting Xen on ARM64 machines with an ITS and the
(EXPERT) ITS Kconfig option enabled.

Signed-off-by: Andre Przywara <andre.przywara@xxxxxxx>
---
 xen/arch/arm/gic-v3-its.c | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/xen/arch/arm/gic-v3-its.c b/xen/arch/arm/gic-v3-its.c
index 07280b3..aebc257 100644
--- a/xen/arch/arm/gic-v3-its.c
+++ b/xen/arch/arm/gic-v3-its.c
@@ -505,6 +505,10 @@ static int gicv3_its_init_single_its(struct host_its 
*hw_its)
         return -ENOMEM;
     writeq_relaxed(0, hw_its->its_base + GITS_CWRITER);
 
+    /* Now enable interrupt translation and command processing on that ITS. */
+    reg = readl_relaxed(hw_its->its_base + GITS_CTLR);
+    writel_relaxed(reg | GITS_CTLR_ENABLE, hw_its->its_base + GITS_CTLR);
+
     return 0;
 }
 
-- 
2.9.0


_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
https://lists.xen.org/xen-devel