[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] [PATCH 4/4] x86: add multiboot2 protocol support for EFI platforms



On Mon, Jan 16, 2017 at 05:02:05AM -0700, Jan Beulich wrote:
> >>> On 13.01.17 at 20:21, <cardoe@xxxxxxxxxx> wrote:
> > Doug v1 - fix incorrect assembly (identified by Andrew Cooper)
> >         - fix issue where the trampoline size was left as 0 and the
> >           way the memory is allocated for the trampolines we would go to
> >           the end of an available section and then subtract off the size
> >           to decide where to place it. The end result was that we would
> >           always copy the trampolines and the 32-bit stack into some
> >           form of reserved memory after the conventional region we
> >           wanted to put things into. On some systems this did not
> >           manifest as a crash while on others it did. Reworked the
> >           changes to always reserve 64kb for both the stack and the size
> >           of the trampolines. Added an ASSERT to make sure we never blow
> >           through this size.
>
> Without having looked at the patch in detail, but knowing I did closely
> look at earlier versions (and iirc I was mostly fine with v10) the way
> the above is written would require me to either inter-diff the patches,
> or re-review the whole thing. For a large patch like this it would be
> rather helpful to be quite a bit more specific as to where exactly in the
> patch changes were made.

I would prefer to not have this patch series applied because it will make me
more difficult to prepare v12. I hope that I will post it in about 2 weeks.
Though I am going to take into account all comments posted by Doug for v11.

Daniel

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
https://lists.xen.org/xen-devel

 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.