Re: [Xen-devel] [PATCH] x86/cpuid: Deal with broken firmware once more

[Boris Ostrovsky <boris.ostrovsky@xxxxxxxxxx>]

On 11/13/2016 06:42 PM, M. Vefa Bicakci wrote:

> I found out that my domU kernels invoke the 'apic_disable' function
> because CONFIG_X86_MPPARSE was not enabled in my kernel configuration,
> which would cause the 'smp_found_config' bit to be unset at boot-up.

smp_found_config is not the problem, it is usually zero for Xen PV guests.

What is the problem is that because of your particular config selection 
acpi_mps_check() fails (with the error message that you mention below) 
and that leads to X86_FEATURE_APIC being cleared. And then we indeed 
switch to APIC noop and things go south after that.
-boris

> This would cause 'init_apic_mappings' to call 'apic_disable', which
> would cause Xen's 'apic' ops structure pointer to be replaced with the
> no-op APIC ops structure's pointer.
>
> The use of the no-op APIC ops structure would in turn cause invalid
> virtual CPU package identifiers to be generated. Invalid CPU package
> identifiers would in turn cause the RAPL module to produce a kernel oops
> due to potentially missing error handling.
>
> It looks like I have been ignoring the following kernel warning which I
> should have noticed a long time ago:
>
>   MPS support code is not built-in.
>   Using acpi=off or acpi=noirq or pci=noacpi may have problem
>
> To all on this e-mail thread, I learned a bit through this exercise, but
> I have also taken a lot of everyone's time and created quite a bit of
> e-mail traffic because of a kernel configuration issue on my end.
>
> My apologies.
>
> Vefa
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
https://lists.xen.org/xen-devel