Re: [Xen-devel] [OSSTEST PATCH v3 25/25] Create XTF branch

[Ian Jackson <ian.jackson@xxxxxxxxxxxxx>]

Wei Liu writes ("Re: [OSSTEST PATCH v3 25/25] Create XTF branch"):
> On Tue, Sep 06, 2016 at 03:03:50PM +0100, Ian Jackson wrote:
> > Wei Liu writes ("[OSSTEST PATCH v3 25/25] Create XTF branch"):
> > > This branch contains Xen and Linux build jobs and all jobs which contain
> > > xtf in their name.
> > 
> > This looks plausible but can you please provide the output from
> > standalone-generate-dump-flight-runvars ?
> 
> Here you go.

Thanks.  It's not entirely clear from your comments above whether this
is a diff for the whole of your series, including 20/25 (add build
jobs), or just for 25/25 (add xtf branch).

The actual diff just shows an additional xtf build job in the
xen-unstable branch, and doesn't mention the new xtf branch even
though you patched cr-for-branches.

All this suggests that you have run
`standalone-generate-dump-flight-runvars xen-unstable' to restrict the
output to that branch only.  I'd like a full diff please.  (At least,
for the series as a whole, but ideally for patch 20 and patch 25
separately.)

Also your commit messages should have a deployment note asking me to

1. Run mg-branch-setup.  You need to specify what value of
   INITIAL-TESTED-VERSION, if any, is appropriate.  If one is
   required, then that means that mg-branch-setup must be run before
   20/25 is pushed, because the change in 20/25 will start to fetch
   the baseline xtf version which is what INITIAL-TESTED-VERSION is.

2. install the new crontab to enable the new branch.

Thanks,
Ian.

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
https://lists.xen.org/xen-devel