Re: [Xen-devel] Unable to boot Xen 4.7-rc4 on HiKey

[Julien Grall <julien.grall@xxxxxxx>]

Hi Tamas,

On 02/06/16 02:09, Tamas K Lengyel wrote:
> On Wed, Jun 1, 2016 at 3:49 PM, Julien Grall <julien.grall@xxxxxxx> wrote:
> > On 01/06/2016 18:10, Tamas K Lengyel wrote:
> > > Hi all,
> > > following the steps from http://wiki.xen.org/wiki/HiKey I'm unable to
> > > get the board to boot Xen. I'm using the Debian reference image from
> > > linaro as base
> > > (https://builds.96boards.org/releases/hikey/linaro/debian/latest/)
> > > and that boots fine both from the SD card directly and through
> > > startup.nsh. However, when I try to boot Xen I see only the following:
> > >
> > > Xen 4.7.0-rc (c/s Mon May 23 12:07:20 2016 +0100 git:8478c94-dirty) EFI
> > > loader
> > > Using configuration file 'xen.cfg'
> > > Image: 0x000000007a121000-0x000000007acb8a70
> > >
> > > After that no output and dom0 never comes online on the network
> > > either. I tried compiling Xen on the device itself in case it was a
> > > problem with my cross-compile setup but no difference. Also with and
> > > without debug=y. Any tips on what might be going wrong here?
> >
> > I gave a quick look at the upstream device-tree of the hikey, the path
> > /smb/uart@f7113000.
> >
> > If you use the upstream device-tree, it should be able to find the correct
> > UART via "stdout-path" and therefore dtuart=... should not be necessary.
> >
> > Let me know if it works for you, and I will update the wiki page.
> No, I removed the dtuart=... part from xen.cfg but there is no
> difference in the output and dom0 never comes up on the network
> either.
Which device-tree are you using?

Regards,

--
Julien Grall

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel