[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] [PATCH 5/9] x86/pvh: Set PVH guest's mode in XEN_DOMCTL_set_address_size



On 06/24/2015 03:57 AM, Jan Beulich wrote:
On 24.06.15 at 04:53, <boris.ostrovsky@xxxxxxxxxx> wrote:
On 06/23/2015 09:22 AM, Jan Beulich wrote:
--- a/xen/arch/x86/hvm/hvm.c
+++ b/xen/arch/x86/hvm/hvm.c
@@ -2320,12 +2320,7 @@ int hvm_vcpu_initialise(struct vcpu *v)
       v->arch.hvm_vcpu.inject_trap.vector = -1;
if ( is_pvh_domain(d) )
-    {
-        v->arch.hvm_vcpu.hcall_64bit = 1;    /* PVH 32bitfixme. */
-        /* This is for hvm_long_mode_enabled(v). */
-        v->arch.hvm_vcpu.guest_efer = EFER_LMA | EFER_LME;
           return 0;
-    }
With this removed, is there any guarantee that hvm_set_mode()
will be called for each vCPU?
IIUIC, toolstack is required to call XEN_DOMCTL_set_address_size which
results in a call to switch_compat/native(), which loop over all VCPUs,
calling set_mode.
I don't recall this being a strict requirement. I think a PV 64-bit
guest would start fine without.

We do call it via libxl__build_pv() -> xc_dom_boot_mem_init() -> arch_setup_mem_init() -> x86_compat().

-boris

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel


 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.