[Xen-devel] [PATCH V3 3/3] Support Xen pv-domains using PAT

[Juergen Gross <jgross@xxxxxxxx>]

With the dynamical mapping between cache modes and pgprot values it is
now possible to use all cache modes via the Xen hypervisor PAT settings
in a pv domain.

All to be done is to read the PAT configuration MSR and set up the
translation tables accordingly.

Signed-off-by: Juergen Gross <jgross@xxxxxxxx>
Reviewed-by: David Vrabel <david.vrabel@xxxxxxxxxx>
---
 arch/x86/xen/enlighten.c | 25 +++++++------------------
 arch/x86/xen/mmu.c       | 48 ++----------------------------------------------
 arch/x86/xen/xen-ops.h   |  1 -
 3 files changed, 9 insertions(+), 65 deletions(-)

diff --git a/arch/x86/xen/enlighten.c b/arch/x86/xen/enlighten.c
index c0cb11f..75ac572 100644
--- a/arch/x86/xen/enlighten.c
+++ b/arch/x86/xen/enlighten.c
@@ -1100,12 +1100,6 @@ static int xen_write_msr_safe(unsigned int msr, unsigned 
low, unsigned high)
                /* Fast syscall setup is all done in hypercalls, so
                   these are all ignored.  Stub them out here to stop
                   Xen console noise. */
-               break;
-
-       case MSR_IA32_CR_PAT:
-               if (smp_processor_id() == 0)
-                       xen_set_pat(((u64)high << 32) | low);
-               break;
 
        default:
                ret = native_write_msr_safe(msr, low, high);
@@ -1554,10 +1548,6 @@ asmlinkage __visible void __init xen_start_kernel(void)
 
        /* Prevent unwanted bits from being set in PTEs. */
        __supported_pte_mask &= ~_PAGE_GLOBAL;
-#if 0
-       if (!xen_initial_domain())
-#endif
-               __supported_pte_mask &= ~(_PAGE_PWT | _PAGE_PCD);
 
        __supported_pte_mask |= _PAGE_IOMAP;
 
@@ -1613,14 +1603,6 @@ asmlinkage __visible void __init xen_start_kernel(void)
         */
        acpi_numa = -1;
 #endif
-#ifdef CONFIG_X86_PAT
-       /*
-        * For right now disable the PAT. We should remove this once
-        * git commit 8eaffa67b43e99ae581622c5133e20b0f48bcef1
-        * (xen/pat: Disable PAT support for now) is reverted.
-        */
-       pat_enabled = 0;
-#endif
        /* Don't do the full vcpu_info placement stuff until we have a
           possible map and a non-dummy shared_info. */
        per_cpu(xen_vcpu, 0) = &HYPERVISOR_shared_info->vcpu_info[0];
@@ -1634,6 +1616,13 @@ asmlinkage __visible void __init xen_start_kernel(void)
        /* Allocate and initialize top and mid mfn levels for p2m structure */
        xen_build_mfn_list_list();
 
+       /*
+        * Modify the cache mode translation tables to match Xen's PAT
+        * configuration.
+        */
+
+       pat_init_cache_modes();
+
        /* keep using Xen gdt for now; no urgent need to change it */
 
 #ifdef CONFIG_X86_32
diff --git a/arch/x86/xen/mmu.c b/arch/x86/xen/mmu.c
index e8a1201..70702e9 100644
--- a/arch/x86/xen/mmu.c
+++ b/arch/x86/xen/mmu.c
@@ -434,13 +434,7 @@ static pteval_t iomap_pte(pteval_t val)
 __visible pteval_t xen_pte_val(pte_t pte)
 {
        pteval_t pteval = pte.pte;
-#if 0
-       /* If this is a WC pte, convert back from Xen WC to Linux WC */
-       if ((pteval & (_PAGE_PAT | _PAGE_PCD | _PAGE_PWT)) == _PAGE_PAT) {
-               WARN_ON(!pat_enabled);
-               pteval = (pteval & ~_PAGE_PAT) | _PAGE_PWT;
-       }
-#endif
+
        if (xen_initial_domain() && (pteval & _PAGE_IOMAP))
                return pteval;
 
@@ -454,48 +448,10 @@ __visible pgdval_t xen_pgd_val(pgd_t pgd)
 }
 PV_CALLEE_SAVE_REGS_THUNK(xen_pgd_val);
 
-/*
- * Xen's PAT setup is part of its ABI, though I assume entries 6 & 7
- * are reserved for now, to correspond to the Intel-reserved PAT
- * types.
- *
- * We expect Linux's PAT set as follows:
- *
- * Idx  PTE flags        Linux    Xen    Default
- * 0                     WB       WB     WB
- * 1            PWT      WC       WT     WT
- * 2        PCD          UC-      UC-    UC-
- * 3        PCD PWT      UC       UC     UC
- * 4    PAT              WB       WC     WB
- * 5    PAT     PWT      WC       WP     WT
- * 6    PAT PCD          UC-      rsv    UC-
- * 7    PAT PCD PWT      UC       rsv    UC
- */
-
-void xen_set_pat(u64 pat)
-{
-       /* We expect Linux to use a PAT setting of
-        * UC UC- WC WB (ignoring the PAT flag) */
-       WARN_ON(pat != 0x0007010600070106ull);
-}
-
 __visible pte_t xen_make_pte(pteval_t pte)
 {
        phys_addr_t addr = (pte & PTE_PFN_MASK);
-#if 0
-       /* If Linux is trying to set a WC pte, then map to the Xen WC.
-        * If _PAGE_PAT is set, then it probably means it is really
-        * _PAGE_PSE, so avoid fiddling with the PAT mapping and hope
-        * things work out OK...
-        *
-        * (We should never see kernel mappings with _PAGE_PSE set,
-        * but we could see hugetlbfs mappings, I think.).
-        */
-       if (pat_enabled && !WARN_ON(pte & _PAGE_PAT)) {
-               if ((pte & (_PAGE_PCD | _PAGE_PWT)) == _PAGE_PWT)
-                       pte = (pte & ~(_PAGE_PCD | _PAGE_PWT)) | _PAGE_PAT;
-       }
-#endif
+
        /*
         * Unprivileged domains are allowed to do IOMAPpings for
         * PCI passthrough, but not map ISA space.  The ISA
diff --git a/arch/x86/xen/xen-ops.h b/arch/x86/xen/xen-ops.h
index 28c7e0b..4ab9298 100644
--- a/arch/x86/xen/xen-ops.h
+++ b/arch/x86/xen/xen-ops.h
@@ -33,7 +33,6 @@ extern unsigned long xen_max_p2m_pfn;
 
 void xen_mm_pin_all(void);
 void xen_mm_unpin_all(void);
-void xen_set_pat(u64);
 
 char * __init xen_memory_setup(void);
 char * xen_auto_xlated_memory_setup(void);
-- 
1.8.4.5


_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel