[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] [PATCH] hw/passthrough: Prevent QEMU from mapping PCI option ROM at address 0



On 12/05/14 16:18, Ian Jackson wrote:
> Malcolm Crossley writes ("[PATCH] hw/passthrough: Prevent QEMU from mapping 
> PCI option ROM at address 0"):
>> The PCI option ROM BAR uses the LSB to indicate if the BAR is enabled.
>> The AMD graphics driver sets the address bit's of the BAR to 0 but leaves the
>> LSB set to 1. Whilst this is not good practice, QEMU should be ignoring the
>> non address parts of the BAR.
>>
>> This patch adds masking of the non address parts of the BAR before comparing
>> the address to 0.
> 
> Is this just for qemu-xen-traditional ?  Is there a corresponding
> patch to qemu-upstream ?
> 
It is just for qemu-xen-traditional, I've just submitted a v4 patch
which expands the masking of the bottom bits up to 4k.

MMIO regions are handled differently in qemu-upstream and so a
corresponding patch is not required.

Malcolm

> Ian.
> 


_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel


 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.