[Xen-devel] Xen On Cubieboard2 is stuck in "Starting kernel ..."

[duqi <duqi_2009@xxxxxxx>]

Hi,

We will have tested the stand alone dtb load progress according this 
wiki：http://wiki.xenproject.org/wiki?title=Xen_ARM_with_Virtualization_Extensions/Allwinner.

For simplicity, I compiled  ramdisk into kernel image.

The Xen version is xen4.4.0 release.
I typed the below command in u-boot,but the Xen was stuck in "Starting 
kernel...."

Could you give me some advice? Thank you very much.

(1)Here is the command I typed:
setenv kernel_addr_r  0x7f600000
setenv fdt_addr       0x7ec00000
setenv xen_addr_r     0x7ea00000

fatload mmc 0 ${xen_addr_r} /boot/xen
fatload mmc 0 ${fdt_addr} /boot/sun7i-a20-cubieboard2.dtb
fatload mmc 0 ${kernel_addr_r} /boot/zImage

setenv fdt_high      0xffffffff 
setenv bootargs "dom0_mem=128M sync_console console=dtuart 
dtuart=/soc@01c00000/serial@01c28000"

fdt addr ${fdt_addr} 0x40000   
fdt resize
fdt chosen
fdt set /chosen \#address-cells <1>
fdt set /chosen \#size-cells <1>
fdt mknod /chosen module@0
fdt set /chosen/module@0 compatible "xen,linux-zimage" "xen,multiboot-module"
fdt set /chosen/module@0 reg <${kernel_addr_r} 0xf00000>
fdt set /chosen/module@0 xen,dom0-bootargs "console=hvc0,115200n8 debug 
ignore_loglevel rw rootwait earlyprintk=xen clk_ignore_unused init=/init"

bootz ${xen_addr_r} - ${fdt_addr}

(2) Here is the debug information:
Kernel image @ 0x7ea00000 [ 0x000000 - 0x0cf700 ]
## Flattened Device Tree blob at 7ec00000
   Booting using the fdt blob at 0x7ec00000
   reserving fdt memory region: addr=7ec00000 size=4000
   Using Device Tree in place at 7ec00000, end 7ec06fff
WARNING: ignoring attempt to set core boot address 7ff88454 on core -1
WARNING: Not kicking secondary CPUs

Starting kernel ...


duqi.
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel