[Xen-devel] [PATCH] serial: Skip over PCIe device which have no quirks (fix AMT regression).

[Konrad Rzeszutek Wilk <konrad@xxxxxxxxxx>]

The "ns16550: Add support for UART present in Broadcom TruManage
capable NetXtreme chips" implies that only devices that are have
an MMIO BAR and are in the quirks table should be processed.

Even the comment at the end says so:

 If we have an io_base, then we succeeded in the lookup

But the code was checking for the !io_base - which is to say if
the io_base was NULL then we would skip scanning.

This means that if we have an communication device followed by
a serial AMT device we would pick the communication device instead
of the MMIO.

See:
00:16.0 Communication controller: Intel Corporation Cougar Point HECI 
Controller #1 (rev 04)
        Subsystem: Intel Corporation Device 2008
        Flags: bus master, fast devsel, latency 0, IRQ 11
        Memory at fb12a000 (64-bit, non-prefetchable) [size=16]
00:16.3 Serial controller: Intel Corporation Cougar Point KT Controller (rev 
04) (prog-if 02 [16550])
        Subsystem: Intel Corporation Device 2008
        Flags: bus master, 66MHz, fast devsel, latency 0, IRQ 17
        I/O ports at f0e0 [size=8]
        Memory at fb129000 (32-bit, non-prefetchable) [size=4K]

pci 0000:00:16.0: [8086:1c3a] type 00 class 0x078000
pci 0000:00:16.3: [8086:1c3d] type 00 class 0x070002

This patch fixes it and allows us to use AMT again.

CC: Aravind Gopalakrishnan <Aravind.Gopalakrishnan@xxxxxxx>
CC: Suravee Suthikulpanit <Suravee.Suthikulpanit@xxxxxxx>
CC: Thomas Lendacky <Thomas.Lendacky@xxxxxxx>
CC: Jan Beulich <jbeulich@xxxxxxxx>
CC: Keir Fraser <keir@xxxxxxx>
Signed-off-by: Konrad Rzeszutek Wilk <konrad.wilk@xxxxxxxxxx>
---
 xen/drivers/char/ns16550.c |    2 +-
 1 files changed, 1 insertions(+), 1 deletions(-)

diff --git a/xen/drivers/char/ns16550.c b/xen/drivers/char/ns16550.c
index 53e49a1..8a908bd 100644
--- a/xen/drivers/char/ns16550.c
+++ b/xen/drivers/char/ns16550.c
@@ -707,7 +707,7 @@ pci_uart_config (struct ns16550 *uart, int skip_amt, int 
bar_idx)
                     }
 
                     /* If we have an io_base, then we succeeded in the lookup 
*/
-                    if ( !uart->io_base )
+                    if ( uart->io_base )
                         continue;
                 }
                 /* IO based */
-- 
1.7.7.6


_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel