[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] [RFC v2 2/4] net: enables interface option to skip IP

On Fri, Feb 21, 2014 at 5:02 AM, Zoltan Kiss <zoltan.kiss@xxxxxxxxxx> wrote:
> Check this how current Xen scripts does routed networking:
> http://wiki.xen.org/wiki/Xen_Networking#Associating_routes_with_virtual_devices
> Note, there are no bridges involved here! As the above page says, the
> backend has to have IP address, maybe it's not true anymore. I'm not too
> familiar with this setup too, I've used it only once.

Thanks, in such case I do think actually adding a bridge, adding the
backend interface to it, and then adding a route to the front end IP
would suffice to cover that case, but I'm pretty limited with test
devices so would appreciate if someone with a setup like that can test
it as an alternative. Please recall that the possible gains here
should be pretty significant in terms of simplification. And of
course, I still also haven't had time / systems to test the NAT


Xen-devel mailing list



Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.