[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [Xen-devel] Ping: [PATCH v5] AMD IOMMU: fix Dom0 device setup failure for host bridges
FYI: PRC is on holiday Thursday and Friday. Will > -----Original Message----- > From: Jan Beulich [mailto:JBeulich@xxxxxxxx] > Sent: Wednesday, September 18, 2013 5:51 AM > To: Zhang, Xiantao > Cc: suravee.suthikulpanit@xxxxxxx; stefan.bader@xxxxxxxxxxxxx; Auld, > Will; xen-devel > Subject: Ping: [PATCH v5] AMD IOMMU: fix Dom0 device setup failure for > host bridges > > Xiantao, > > despite the title this has implications on VT-d, and hence a review/ > ack from you would be much appreciated. > > Jan > > >>> On 12.09.13 at 10:17, "Jan Beulich" <JBeulich@xxxxxxxx> wrote: > > The host bridge device (i.e. 0x18 for AMD) does not require IOMMU, > and > > therefore is not included in the IVRS. The current logic tries to map > > all PCI devices to an IOMMU. In this case, "xl dmesg" shows the > > following message on AMD sytem. > > > > (XEN) setup 0000:00:18.0 for d0 failed (-19) > > (XEN) setup 0000:00:18.1 for d0 failed (-19) > > (XEN) setup 0000:00:18.2 for d0 failed (-19) > > (XEN) setup 0000:00:18.3 for d0 failed (-19) > > (XEN) setup 0000:00:18.4 for d0 failed (-19) > > (XEN) setup 0000:00:18.5 for d0 failed (-19) > > > > This patch adds a new device type (i.e. DEV_TYPE_PCI_HOST_BRIDGE) > > which corresponds to PCI class code 0x06 and sub-class 0x00. Then, it > > uses this new type to filter when trying to map device to IOMMU. > > > > Signed-off-by: Suravee Suthikulpanit <suravee.suthikulpanit@xxxxxxx> > > Reported-by: Stefan Bader <stefan.bader@xxxxxxxxxxxxx> > > > > On VT-d refuse (un)mapping host bridges for other than the hardware > > domain. > > > > Coding style cleanup. > > > > Signed-off-by: Jan Beulich <jbeulich@xxxxxxxx> > > > > --- a/xen/drivers/passthrough/amd/pci_amd_iommu.c > > +++ b/xen/drivers/passthrough/amd/pci_amd_iommu.c > > @@ -147,9 +147,10 @@ static void amd_iommu_setup_domain_devic > > > > amd_iommu_flush_device(iommu, req_id); > > > > - AMD_IOMMU_DEBUG("Setup I/O page table: device id = %#x, " > > + AMD_IOMMU_DEBUG("Setup I/O page table: device id = %#x, type > = %#x, " > > "root table = %#"PRIx64", " > > - "domain = %d, paging mode = %d\n", req_id, > > + "domain = %d, paging mode = %d\n", > > + req_id, pdev->type, > > page_to_maddr(hd->root_table), > > hd->domain_id, hd->paging_mode); > > } > > @@ -175,6 +176,15 @@ static int __init amd_iommu_setup_dom0_d > > > > if ( unlikely(!iommu) ) > > { > > + /* Filter the bridge devices */ > > + if ( pdev->type == DEV_TYPE_PCI_HOST_BRIDGE ) > > + { > > + AMD_IOMMU_DEBUG("Skipping host bridge > %04x:%02x:%02x.%u\n", > > + pdev->seg, PCI_BUS(bdf), PCI_SLOT(bdf), > > + PCI_FUNC(bdf)); > > + return 0; > > + } > > + > > AMD_IOMMU_DEBUG("No iommu for device %04x:%02x:%02x.%u\n", > > pdev->seg, pdev->bus, > > PCI_SLOT(devfn), PCI_FUNC(devfn)); > > --- a/xen/drivers/passthrough/pci.c > > +++ b/xen/drivers/passthrough/pci.c > > @@ -194,9 +194,6 @@ static struct pci_dev *alloc_pdev(struct > > u16 cap; > > u8 sec_bus, sub_bus; > > > > - case DEV_TYPE_PCIe_BRIDGE: > > - break; > > - > > case DEV_TYPE_PCIe2PCI_BRIDGE: > > case DEV_TYPE_LEGACY_PCI_BRIDGE: > > sec_bus = pci_conf_read8(pseg->nr, bus, PCI_SLOT(devfn), > > @@ -244,6 +241,8 @@ static struct pci_dev *alloc_pdev(struct > > break; > > > > case DEV_TYPE_PCI: > > + case DEV_TYPE_PCIe_BRIDGE: > > + case DEV_TYPE_PCI_HOST_BRIDGE: > > break; > > > > default: > > @@ -697,6 +696,7 @@ void pci_release_devices(struct domain * > > spin_unlock(&pcidevs_lock); > > } > > > > +#define PCI_CLASS_BRIDGE_HOST 0x0600 > > #define PCI_CLASS_BRIDGE_PCI 0x0604 > > > > enum pdev_type pdev_type(u16 seg, u8 bus, u8 devfn) @@ -720,6 +720,8 > > @@ enum pdev_type pdev_type(u16 seg, u8 bus > > return DEV_TYPE_PCI2PCIe_BRIDGE; > > } > > return DEV_TYPE_PCIe_BRIDGE; > > + case PCI_CLASS_BRIDGE_HOST: > > + return DEV_TYPE_PCI_HOST_BRIDGE; > > > > case 0x0000: case 0xffff: > > return DEV_TYPE_PCI_UNKNOWN; > > --- a/xen/drivers/passthrough/vtd/intremap.c > > +++ b/xen/drivers/passthrough/vtd/intremap.c > > @@ -442,6 +442,7 @@ static void set_msi_source_id(struct pci > > case DEV_TYPE_PCIe_ENDPOINT: > > case DEV_TYPE_PCIe_BRIDGE: > > case DEV_TYPE_PCIe2PCI_BRIDGE: > > + case DEV_TYPE_PCI_HOST_BRIDGE: > > switch ( pdev->phantom_stride ) > > { > > case 1: sq = SQ_13_IGNORE_3; break; > > --- a/xen/drivers/passthrough/vtd/iommu.c > > +++ b/xen/drivers/passthrough/vtd/iommu.c > > @@ -1433,6 +1433,15 @@ static int domain_context_mapping( > > > > switch ( pdev->type ) > > { > > + case DEV_TYPE_PCI_HOST_BRIDGE: > > + if ( iommu_verbose ) > > + dprintk(VTDPREFIX, "d%d:Hostbridge: skip > %04x:%02x:%02x.%u map\n", > > + domain->domain_id, seg, bus, > > + PCI_SLOT(devfn), PCI_FUNC(devfn)); > > + if ( !is_hardware_domain(domain) ) > > + return -EPERM; > > + break; > > + > > case DEV_TYPE_PCIe_BRIDGE: > > case DEV_TYPE_PCIe2PCI_BRIDGE: > > case DEV_TYPE_LEGACY_PCI_BRIDGE: > > @@ -1563,6 +1572,15 @@ static int domain_context_unmap( > > > > switch ( pdev->type ) > > { > > + case DEV_TYPE_PCI_HOST_BRIDGE: > > + if ( iommu_verbose ) > > + dprintk(VTDPREFIX, "d%d:Hostbridge: skip > %04x:%02x:%02x.%u unmap\n", > > + domain->domain_id, seg, bus, > > + PCI_SLOT(devfn), PCI_FUNC(devfn)); > > + if ( !is_hardware_domain(domain) ) > > + return -EPERM; > > + goto out; > > + > > case DEV_TYPE_PCIe_BRIDGE: > > case DEV_TYPE_PCIe2PCI_BRIDGE: > > case DEV_TYPE_LEGACY_PCI_BRIDGE: > > --- a/xen/include/xen/pci.h > > +++ b/xen/include/xen/pci.h > > @@ -63,6 +63,7 @@ struct pci_dev { > > DEV_TYPE_PCIe2PCI_BRIDGE, // PCIe-to-PCI/PCIx bridge > > DEV_TYPE_PCI2PCIe_BRIDGE, // PCI/PCIx-to-PCIe bridge > > DEV_TYPE_LEGACY_PCI_BRIDGE, // Legacy PCI bridge > > + DEV_TYPE_PCI_HOST_BRIDGE, // PCI Host bridge > > DEV_TYPE_PCI, > > } type; > > > _______________________________________________ Xen-devel mailing list Xen-devel@xxxxxxxxxxxxx http://lists.xen.org/xen-devel
|
Lists.xenproject.org is hosted with RackSpace, monitoring our |