[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] [PATCH] pl011: early_panic if baud rate not set in hardware



On Thu, 2013-08-22 at 17:34 +0100, Julien Grall wrote:
> On 08/22/2013 05:01 PM, Ian Campbell wrote:
> > Now that the driver defaults to BAUD_AUTO this can happen if the early uart 
> > !=
> > console or if early printk isn't in use.
> 
> Does the fast model set correctly the baud rate?
> 
> > The following division by zero causes a trap but that uses regular printk 
> > and
> > not early_printk, so it is never seen.
> 
> That's annoying. I often have this problem, is there any plan to support
> early print in printk?

I didn't get to this like I thought I might last week

> > Signed-off-by: Ian Campbell <ian.campbell@xxxxxxxxxx>
> Acked-by: Julien Grall <julien.grall@xxxxxxxxxx>

Applied, thanks.


_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel


 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.