[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-devel] [PATCH] xen/pci: Deal with toolstack missing an 'XenbusStateClosing'.



On 06/10/2013 10:06 PM, Konrad Rzeszutek Wilk wrote:
There are two tool-stack that can instruct the Xen PCI frontend
and backend to change states: 'xm' (Python code with a daemon),
and 'xl' (C library - does not keep state changes).

With the 'xm', the path to disconnect a PCI device (xm pci-detach
<guest> <BDF>)is:

4(Connected)->7(Reconfiguring*)-> 8(Reconfigured)-> 4(Connected)->5(Closing*).

The * is for states that the tool-stack sets. For 'xl', it is similar:

4(Connected)->7(Reconfiguring*)-> 8(Reconfigured)-> 4(Connected)

Both of them also tear down the XenBus structure, so the backend
state ends up going in the 3(Initialised) and calls pcifront_xenbus_remove.

So I looked a little bit into this; there are actually two different states that happen as part of this handshake. In order to disonnect a *device*, xl signals using the *bus* state, like this:
* Wait for the *bus* to be in state 4(Connected)
* Set the *device* state to 5(Closing)
* Set the *bus* state to 7(Reconfiguring)
* Wait for the *bus* state to return to 4(Connected)

So are all of these states you see the *bus* state? And why would you disconnect the whole pci bus if you're only removing one device?

 -George

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel


 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.