Re: [Xen-devel] Xen-ARM couldn't boot up

[Ian Campbell <ian.campbell@xxxxxxxxxx>]

On Tue, 2013-03-05 at 08:46 +0000, Josh Zhao wrote:
> Hi, 
> 
> There is no xen infomation output from Fastmodel.

So no output at all?
[...]

>    make dist-xen XEN_TARGET_ARCH=arm32 
> CROSS_COMPILE=arm-unknown-linux-gnueabi-

Did you supply a DTB? Normally this would involve setting
CONFIG_DTB_FILE as described by
http://wiki.xen.org/wiki/Xen_ARM_with_Virtualization_Extensions

> 3)  model_shell
> cadi_system_Linux-Release-GCC-4.1.so/project/xen/xen/dist/install/boot/xen-syms-4.3-unstable
>  -C 
> motherboard.flashloader0.fname=/project/xen/dom0/linux/arch/arm/boot/zImage

You need to use xen-4.3-unstable not the xen-syms version. I don't know
if that is what is causing your issue though.

Ian.


_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel