Re: [Xen-devel] [PATCH v7] cover: Coverage support

[George Dunlap <george.dunlap@xxxxxxxxxxxxx>]

On 07/02/13 11:27, Frediano Ziglio wrote:
> Updated set of patches for coverage.
>
> Changes:
> - remove operation to check if coverage enabled
> - add operation to read and reset coverage at same time
> - updated utility to refrect changes above
I've done a once-over and in principle I think this is a good series.  
Thanks for doing it -- I think Xen has needed this for some time.  Just 
a couple of high-level comments (and I haven't been following the 
discussion, so please forgive me if I'm contradicting something someone 
said somewhere else):
First, re the name -- is there any reason not to call it "gcov" (or 
"xgcov" or something like that) in the patch series and the Xen 
command-line option?  Since we're using the gcov format and the intent 
(I presume) is to use the gcov tools to do the actual analysis,
Secondly, there doesn't seem to be any documentation.  A definition of 
the Xen command-line term is an absolute minimum, and a brief markdown 
how-to explaining how to enable the option and use it would be much 
appreciated.
 -George

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel