[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Xen-devel] [PATCH 1 of 1] x86/kexec: Change NMI and MCE handling on kexec path
On 06/12/12 15:56, Andrew Cooper wrote:
Experimentally, certain crash kernels will triple fault very early after
starting if started with NMIs disabled. This was discovered when
experimenting with a debug keyhandler which deliberately created a
reentrant NMI, causing stack corruption.
Because of this discovered bug, and that the future changes to the NMI
handling will make the kexec path more fragile, take the time now to
bullet-proof the kexec behaviour to be safer in more circumstances.
This patch adds three new low level routines:
* nmi_crash
This is a special NMI handler for using during a kexec crash.
* enable_nmis
This function enables NMIs by executing an iret-to-self, to
disengage the hardware NMI latch.
* trap_nop
This is a no op handler which irets immediately. It is actually in
the middle of enable_nmis to reuse the iret instruction, without
having a single lone aligned iret inflating the code side.
As a result, the new behaviour of the kexec_crash path is:
nmi_shootdown_cpus() will:
* Disable interrupt stack tables.
Disabling ISTs will prevent stack corruption from future NMIs and
MCEs. As Xen is going to crash, we are not concerned with the
security race condition with 'sysret'; any guest which managed to
benefit from the race condition will only be able execute a handful
of instructions before it will be killed anyway, and a guest is
still unable to trigger the race condition in the first place.
* Swap the NMI trap handlers.
The crashing pcpu gets the nop handler, to prevent it getting stuck in
an NMI context, causing a hang instead of crash. The non-crashing
pcpus all get the nmi_crash handler which is designed never to
return.
do_nmi_crash() will:
* Save the crash notes and shut the pcpu down.
There is now an extra per-cpu variable to prevent us from executing
this multiple times. In the case where we reenter midway through,
attempt the whole operation again in preference to not completing
it in the first place.
* Set up another NMI at the LAPIC.
Even when the LAPIC has been disabled, the ID and command registers
are still usable. As a result, we can deliberately queue up a new
NMI to re-interrupt us later if NMIs get unlatched. Because of the
call to __stop_this_cpu(), we have to hand craft self_nmi() to be
safe from General Protection Faults.
* Fall into infinite loop.
machine_kexec() will:
* Swap the MCE handlers to be a nop.
We cannot prevent MCEs from being delivered when we pass off to the
crash kernel, and the less Xen context is being touched the better.
* Explicitly enable NMIs.
Signed-off-by: Andrew Cooper <andrew.cooper3@xxxxxxxxxx>
--
Changes since v1:
* Reintroduce atomic_dec(&waiting_for_crash_ipi); which got missed
during the original refactoring.
* Fold trap_nop into the middle of enable_nmis to reuse the iret.
* Expand comments in areas as per Tim's suggestions.
diff -r bc624b00d6d6 -r 01158d25f3bf xen/arch/x86/crash.c
--- a/xen/arch/x86/crash.c
+++ b/xen/arch/x86/crash.c
@@ -32,41 +32,102 @@
static atomic_t waiting_for_crash_ipi;
static unsigned int crashing_cpu;
+static DEFINE_PER_CPU_READ_MOSTLY(bool_t, crash_save_done);
-static int crash_nmi_callback(struct cpu_user_regs *regs, int cpu)
+/* This becomes the NMI handler for non-crashing CPUs. */
+void __attribute__((noreturn)) do_nmi_crash(struct cpu_user_regs *regs)
{
- /* Don't do anything if this handler is invoked on crashing cpu.
- * Otherwise, system will completely hang. Crashing cpu can get
- * an NMI if system was initially booted with nmi_watchdog parameter.
+ /* nmi_shootdown_cpus() should ensure that this assertion is correct. */
+ ASSERT( crashing_cpu != smp_processor_id() );
+
+ /* Save crash information and shut down CPU. Attempt only once. */
+ if ( ! this_cpu(crash_save_done) )
+ {
+ kexec_crash_save_cpu();
+ __stop_this_cpu();
+
+ this_cpu(crash_save_done) = 1;
+
+ atomic_dec(&waiting_for_crash_ipi);
+ }
+
+ /* Poor mans self_nmi(). __stop_this_cpu() has reverted the LAPIC
+ * back to its boot state, so we are unable to rely on the regular
+ * apic_* functions, due to 'x2apic_enabled' being possibly wrong.
+ * (The likely scenario is that we have reverted from x2apic mode to
+ * xapic, at which point #GPFs will occur if we use the apic_*
+ * functions)
+ *
+ * The ICR and APIC ID of the LAPIC are still valid even during
+ * software disable (Intel SDM Vol 3, 10.4.7.2). As a result, we
+ * can deliberately queue up another NMI at the LAPIC which will not
+ * be delivered as the hardware NMI latch is currently in effect.
+ * This means that if NMIs become unlatched (e.g. following a
+ * non-fatal MCE), the LAPIC will force us back here rather than
+ * wandering back into regular Xen code.
*/
- if ( cpu == crashing_cpu )
- return 1;
- local_irq_disable();
+ switch ( current_local_apic_mode() )
+ {
+ u32 apic_id;
- kexec_crash_save_cpu();
+ case APIC_MODE_X2APIC:
+ apic_id = apic_rdmsr(APIC_ID);
- __stop_this_cpu();
+ apic_wrmsr(APIC_ICR, APIC_DM_NMI | APIC_DEST_PHYSICAL | ((u64)apic_id
<< 32));
+ break;
- atomic_dec(&waiting_for_crash_ipi);
+ case APIC_MODE_XAPIC:
+ apic_id = GET_xAPIC_ID(apic_mem_read(APIC_ID));
+
+ while ( apic_mem_read(APIC_ICR) & APIC_ICR_BUSY )
+ cpu_relax();
+
+ apic_mem_write(APIC_ICR2, apic_id << 24);
+ apic_mem_write(APIC_ICR, APIC_DM_NMI | APIC_DEST_PHYSICAL);
+ break;
+
+ default:
+ break;
+ }
for ( ; ; )
halt();
-
- return 1;
}
static void nmi_shootdown_cpus(void)
{
unsigned long msecs;
+ int i, cpu = smp_processor_id();
local_irq_disable();
- crashing_cpu = smp_processor_id();
+ crashing_cpu = cpu;
local_irq_count(crashing_cpu) = 0;
atomic_set(&waiting_for_crash_ipi, num_online_cpus() - 1);
- /* Would it be better to replace the trap vector here? */
- set_nmi_callback(crash_nmi_callback);
+
+ /* Change NMI trap handlers. Non-crashing pcpus get nmi_crash which
+ * invokes do_nmi_crash (above), which cause them to write state and
+ * fall into a loop. The crashing pcpu gets the nop handler to
+ * cause it to return to this function ASAP.
+ *
+ * Furthermore, disable stack tables for NMIs and MCEs to prevent
+ * race conditions resulting in corrupt stack frames. As Xen is
+ * about to die, we no longer care about the security-related race
+ * condition with 'sysret' which ISTs are designed to solve.
+ */
+ for ( i = 0; i < nr_cpu_ids; ++i )
+ if ( idt_tables[i] )
+ {
+ idt_tables[i][TRAP_nmi].a &= ~(7UL << 32);
+ idt_tables[i][TRAP_machine_check].a &= ~(7UL << 32);
+
+ if ( i == cpu )
+ _set_gate(&idt_tables[i][TRAP_nmi], 14, 0, &trap_nop);
+ else
+ _set_gate(&idt_tables[i][TRAP_nmi], 14, 0, &nmi_crash);
+ }
+
/* Ensure the new callback function is set before sending out the NMI. */
wmb();
diff -r bc624b00d6d6 -r 01158d25f3bf xen/arch/x86/machine_kexec.c
--- a/xen/arch/x86/machine_kexec.c
+++ b/xen/arch/x86/machine_kexec.c
@@ -87,6 +87,22 @@ void machine_kexec(xen_kexec_image_t *im
*/
local_irq_disable();
+ /* Now regular interrupts are disabled, we need to reduce the impact
+ * of interrupts not disabled by 'cli'.
+ *
+ * The NMI handlers have already been set up nmi_shootdown_cpus(). All
+ * pcpus other than us have the nmi_crash handler, while we have the nop
+ * handler.
+ *
+ * The MCE handlers touch extensive areas of Xen code and data. At this
+ * point, there is nothing we can usefully do, so set the nop handler.
+ */
+ set_intr_gate(TRAP_machine_check, &trap_nop);
+
+ /* Explicitly enable NMIs on this CPU. Some crashdump kernels do
+ * not like running with NMIs disabled. */
+ enable_nmis();
+
/*
* compat_machine_kexec() returns to idle pagetables, which requires us
* to be running on a static GDT mapping (idle pagetables have no GDT
diff -r bc624b00d6d6 -r 01158d25f3bf xen/arch/x86/x86_64/entry.S
--- a/xen/arch/x86/x86_64/entry.S
+++ b/xen/arch/x86/x86_64/entry.S
@@ -635,11 +635,45 @@ ENTRY(nmi)
movl $TRAP_nmi,4(%rsp)
jmp handle_ist_exception
+ENTRY(nmi_crash)
+ cli
+ pushq $0
+ movl $TRAP_nmi,4(%rsp)
+ SAVE_ALL
+ movq %rsp,%rdi
+ callq do_nmi_crash /* Does not return */
+ ud2
+
ENTRY(machine_check)
pushq $0
movl $TRAP_machine_check,4(%rsp)
jmp handle_ist_exception
+/* Enable NMIs. No special register assumptions, and all preserved. */
+ENTRY(enable_nmis)
+ pushq %rax
+ movq %rsp, %rax /* Grab RSP before pushing */
+
+ /* Set up stack frame */
+ pushq $0 /* SS */
+ pushq %rax /* RSP */
+ pushfq /* RFLAGS */
+ pushq $__HYPERVISOR_CS /* CS */
+ leaq 1f(%rip),%rax
+ pushq %rax /* RIP */
I did see Jan's comment to add "trap_nop" to this section of code, and I
do agree that saving 14 bytes by not having a single iret in it's own
aligned block is a good thing, but how about:
+ /* Set up stack frame */
+ pushq $0 /* SS */
+ pushq %rax /* RSP */
+ pushfq /* RFLAGS */
+ pushq $__HYPERVISOR_CS /* CS */
+ leaq 1f(%rip),%rax
+ pushq %rax /* RIP */
+ iretq /* Disable the hardware NMI latch */
+1:
+ popq %rax
+ retq
+
+/* No op trap handler. Required for kexec crash path.
+ * It is not used in performance critical code, and saves having a single
+ * lone aligned iret. It does not use ENTRY to declare the symbol to avoid the
+ * explicit alignment. */
+.globl trap_nop;
+trap_nop:
+
+ iretq /* Disable the hardware NMI latch */
We still have the benefit of not wasting 14 bytes on aligning a single
iretq, but the code to "do a iretq to enable nmi" is a bit cleaner.
--
Mats
+
+/* No op trap handler. Required for kexec crash path.
+ * It is not used in performance critical code, and saves having a single
+ * lone aligned iret. It does not use ENTRY to declare the symbol to avoid the
+ * explicit alignment. */
+.globl trap_nop;
+trap_nop:
+
+ iretq /* Disable the hardware NMI latch */
+1:
+ popq %rax
+ retq
+
.section .rodata, "a", @progbits
ENTRY(exception_table)
diff -r bc624b00d6d6 -r 01158d25f3bf xen/include/asm-x86/processor.h
--- a/xen/include/asm-x86/processor.h
+++ b/xen/include/asm-x86/processor.h
@@ -517,6 +517,7 @@ void do_ ## _name(struct cpu_user_regs *
DECLARE_TRAP_HANDLER(divide_error);
DECLARE_TRAP_HANDLER(debug);
DECLARE_TRAP_HANDLER(nmi);
+DECLARE_TRAP_HANDLER(nmi_crash);
DECLARE_TRAP_HANDLER(int3);
DECLARE_TRAP_HANDLER(overflow);
DECLARE_TRAP_HANDLER(bounds);
@@ -535,6 +536,9 @@ DECLARE_TRAP_HANDLER(alignment_check);
DECLARE_TRAP_HANDLER(spurious_interrupt_bug);
#undef DECLARE_TRAP_HANDLER
+void trap_nop(void);
+void enable_nmis(void);
+
void syscall_enter(void);
void sysenter_entry(void);
void sysenter_eflags_saved(void);
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel
|
