|
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [Xen-devel] [PATCH RFC 0/8] console improvements
On 11/09/2012 11:11, "Jan Beulich" <JBeulich@xxxxxxxx> wrote:
> This series adds support for an EHCI debug port based console, and
> does some other improvements and cleanup noticed to be desirable
> during the implementation of the former as follow-up.
>
> 1: x86: allow early use of fixmaps
> 2: console: prepare for non-COMn port support
> 3: console: add EHCI debug port based serial console
> 4: serial: avoid fully initializing unused consoles
> 5: ns16550: MMIO adjustments
> 6: ns16550: PCI initialization adjustments
> 7: ns16550: command line parsing adjustments
> 8: drop tx_fifo_size
>
> Note that this also requires a Dom0 kernel side enhancement,
> which I'm reproducing below for reference (intending to submit
> this only when the public interface change on the hypervisor
> side is approved, which in turn will take its time due to the
> current feature freeze).
>
> Signed-off-by: Jan Beulich <jbeulich@xxxxxxxx>
Acked-by: Keir Fraser <keir@xxxxxxx>
> --- a/drivers/usb/early/ehci-dbgp.c
> +++ b/drivers/usb/early/ehci-dbgp.c
> @@ -491,7 +491,7 @@ static int ehci_wait_for_port(int port);
> * Return -ENODEV for any general failure
> * Return -EIO if wait for port fails
> */
> -int dbgp_external_startup(void)
> +static int _dbgp_external_startup(void)
> {
> int devnum;
> struct usb_debug_descriptor dbgp_desc;
> @@ -613,6 +613,11 @@ err:
> goto try_again;
> return -ENODEV;
> }
> +
> +int dbgp_external_startup(struct usb_hcd *hcd)
> +{
> + return xen_dbgp_external_startup(hcd) ?: _dbgp_external_startup();
> +}
> EXPORT_SYMBOL_GPL(dbgp_external_startup);
>
> static int ehci_reset_port(int port)
> @@ -804,7 +809,7 @@ try_next_port:
> dbgp_ehci_status("ehci skip - already configured");
> }
>
> - ret = dbgp_external_startup();
> + ret = _dbgp_external_startup();
> if (ret == -EIO)
> goto next_debug_port;
>
> @@ -934,7 +939,7 @@ static void early_dbgp_write(struct cons
> ctrl = readl(&ehci_debug->control);
> if (!(ctrl & DBGP_ENABLED)) {
> dbgp_not_safe = 1;
> - dbgp_external_startup();
> + _dbgp_external_startup();
> } else {
> cmd |= CMD_RUN;
> writel(cmd, &ehci_regs->command);
> @@ -974,10 +979,14 @@ struct console early_dbgp_console = {
> .index = -1,
> };
>
> -int dbgp_reset_prep(void)
> +int dbgp_reset_prep(struct usb_hcd *hcd)
> {
> + int ret = xen_dbgp_reset_prep(hcd);
> u32 ctrl;
>
> + if (ret)
> + return ret;
> +
> dbgp_not_safe = 1;
> if (!ehci_debug)
> return 0;
> --- a/drivers/usb/host/ehci-hcd.c
> +++ b/drivers/usb/host/ehci-hcd.c
> @@ -321,7 +321,7 @@ static int ehci_reset (struct ehci_hcd *
>
> /* If the EHCI debug controller is active, special care must be
> * taken before and after a host controller reset */
> - if (ehci->debug && !dbgp_reset_prep())
> + if (ehci->debug && !dbgp_reset_prep(ehci_to_hcd(ehci)))
> ehci->debug = NULL;
>
> command |= CMD_RESET;
> @@ -345,7 +345,7 @@ static int ehci_reset (struct ehci_hcd *
> tdi_reset (ehci);
>
> if (ehci->debug)
> - dbgp_external_startup();
> + dbgp_external_startup(ehci_to_hcd(ehci));
>
> ehci->port_c_suspend = ehci->suspended_ports =
> ehci->resuming_ports = 0;
> --- a/drivers/usb/host/ehci-hub.c
> +++ b/drivers/usb/host/ehci-hub.c
> @@ -347,10 +347,10 @@ static int ehci_bus_resume (struct usb_h
> }
>
> if (unlikely(ehci->debug)) {
> - if (!dbgp_reset_prep())
> + if (!dbgp_reset_prep(hcd))
> ehci->debug = NULL;
> else
> - dbgp_external_startup();
> + dbgp_external_startup(hcd);
> }
>
> /* Ideally and we've got a real resume here, and no port's power
> --- a/drivers/xen/Makefile
> +++ b/drivers/xen/Makefile
> @@ -21,6 +21,7 @@ CFLAGS_features.o := $(nostackp)
> endif
>
> priv-$(CONFIG_PCI) := pci.o
> +priv-$(CONFIG_USB_SUPPORT) += dbgp.o
>
> obj-$(CONFIG_XEN) += features.o $(xen-backend-y) $(xen-backend-m)
> obj-$(CONFIG_XEN_PRIVILEGED_GUEST) += $(priv-y)
> @@ -37,7 +38,7 @@ obj-$(CONFIG_XEN_SYS_HYPERVISOR) += sys-
> obj-$(CONFIG_XEN_PVHVM) += platform-pci.o
> obj-$(CONFIG_XEN_TMEM) += tmem.o
> obj-$(CONFIG_SWIOTLB_XEN) += swiotlb-xen.o
> -obj-$(CONFIG_XEN_DOM0) += pci.o
> +obj-$(CONFIG_XEN_DOM0) += pci.o dbgp.o
> obj-$(CONFIG_XEN_PCIDEV_BACKEND) += xen-pciback/
> obj-$(CONFIG_XEN_PRIVCMD) += $(xen-privcmd_y)
> obj-$(CONFIG_XEN_ACPI_PROCESSOR) += xen-acpi-processor.o
> --- /dev/null
> +++ b/drivers/xen/dbgp.c
> @@ -0,0 +1,48 @@
> +#include <linux/pci.h>
> +#include <linux/usb.h>
> +#include <linux/usb/ehci_def.h>
> +#include <linux/usb/hcd.h>
> +#include <asm/xen/hypercall.h>
> +#include <xen/interface/physdev.h>
> +#include <xen/xen.h>
> +
> +static int xen_dbgp_op(struct usb_hcd *hcd, int op)
> +{
> + const struct device *ctrlr = hcd_to_bus(hcd)->controller;
> + struct physdev_dbgp_op dbgp;
> +
> + if (!xen_initial_domain())
> + return 0;
> +
> + dbgp.op = op;
> +
> +#ifdef CONFIG_PCI
> + if (ctrlr->bus == &pci_bus_type) {
> + const struct pci_dev *pdev = to_pci_dev(ctrlr);
> +
> + dbgp.u.pci.seg = pci_domain_nr(pdev->bus);
> + dbgp.u.pci.bus = pdev->bus->number;
> + dbgp.u.pci.devfn = pdev->devfn;
> + dbgp.bus = PHYSDEVOP_DBGP_BUS_PCI;
> + } else
> +#endif
> + dbgp.bus = PHYSDEVOP_DBGP_BUS_UNKNOWN;
> +
> + return HYPERVISOR_physdev_op(PHYSDEVOP_dbgp_op, &dbgp);
> +}
> +
> +int xen_dbgp_reset_prep(struct usb_hcd *hcd)
> +{
> + return xen_dbgp_op(hcd, PHYSDEVOP_DBGP_RESET_PREPARE);
> +}
> +
> +int xen_dbgp_external_startup(struct usb_hcd *hcd)
> +{
> + return xen_dbgp_op(hcd, PHYSDEVOP_DBGP_RESET_DONE);
> +}
> +
> +#ifndef CONFIG_EARLY_PRINTK_DBGP
> +#include <linux/export.h>
> +EXPORT_SYMBOL_GPL(xen_dbgp_reset_prep);
> +EXPORT_SYMBOL_GPL(xen_dbgp_external_startup);
> +#endif
> --- a/include/linux/usb/ehci_def.h
> +++ b/include/linux/usb/ehci_def.h
> @@ -207,18 +207,35 @@ extern int __init early_dbgp_init(char *
> extern struct console early_dbgp_console;
> #endif /* CONFIG_EARLY_PRINTK_DBGP */
>
> +struct usb_hcd;
> +
> +#if defined(CONFIG_XEN_PRIVILEGED_GUEST) || defined(CONFIG_XEN_DOM0)
> +extern int xen_dbgp_reset_prep(struct usb_hcd *);
> +extern int xen_dbgp_external_startup(struct usb_hcd *);
> +#else
> +static inline int xen_dbgp_reset_prep(struct usb_hcd *hcd)
> +{
> + return 1; /* Shouldn't this be 0? */
> +}
> +
> +static inline int xen_dbgp_external_startup(struct usb_hcd *hcd)
> +{
> + return -1;
> +}
> +#endif
> +
> #ifdef CONFIG_EARLY_PRINTK_DBGP
> /* Call backs from ehci host driver to ehci debug driver */
> -extern int dbgp_external_startup(void);
> -extern int dbgp_reset_prep(void);
> +extern int dbgp_external_startup(struct usb_hcd *);
> +extern int dbgp_reset_prep(struct usb_hcd *hcd);
> #else
> -static inline int dbgp_reset_prep(void)
> +static inline int dbgp_reset_prep(struct usb_hcd *hcd)
> {
> - return 1;
> + return xen_dbgp_reset_prep(hcd);
> }
> -static inline int dbgp_external_startup(void)
> +static inline int dbgp_external_startup(struct usb_hcd *hcd)
> {
> - return -1;
> + return xen_dbgp_external_startup(hcd);
> }
> #endif
>
> --- a/include/xen/interface/physdev.h
> +++ b/include/xen/interface/physdev.h
> @@ -307,6 +307,24 @@ struct physdev_pci_device {
> typedef struct physdev_pci_device physdev_pci_device_t;
> DEFINE_XEN_GUEST_HANDLE(physdev_pci_device_t);
>
> +#define PHYSDEVOP_DBGP_RESET_PREPARE 1
> +#define PHYSDEVOP_DBGP_RESET_DONE 2
> +
> +#define PHYSDEVOP_DBGP_BUS_UNKNOWN 0
> +#define PHYSDEVOP_DBGP_BUS_PCI 1
> +
> +#define PHYSDEVOP_dbgp_op 29
> +struct physdev_dbgp_op {
> + /* IN */
> + uint8_t op;
> + uint8_t bus;
> + union {
> + struct physdev_pci_device pci;
> + } u;
> +};
> +typedef struct physdev_dbgp_op physdev_dbgp_op_t;
> +DEFINE_XEN_GUEST_HANDLE(physdev_dbgp_op_t);
> +
> /*
> * Notify that some PIRQ-bound event channels have been unmasked.
> * ** This command is obsolete since interface version 0x00030202 and is **
>
>
> _______________________________________________
> Xen-devel mailing list
> Xen-devel@xxxxxxxxxxxxx
> http://lists.xen.org/xen-devel
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel
|
![]() |
Lists.xenproject.org is hosted with RackSpace, monitoring our |