Re: [Xen-devel] [PATCH 10/11] arm: use bootargs for the command line

[Ian Campbell <Ian.Campbell@xxxxxxxxxx>]

On Thu, 2012-03-22 at 14:22 +0000, Ian Campbell wrote:
> On Mon, 2012-03-19 at 17:52 +0000, David Vrabel wrote:
> > From: David Vrabel <david.vrabel@xxxxxxxxxx>
> > 
> > Use the /chosen node's bootargs parameter for the Xen command line.
> > Parse it early on before the serial console is setup.
> > 
> > Signed-off-by: David Vrabel <david.vrabel@xxxxxxxxxx>
> 
> With this my hypervisor hangs after:
>         - UART enabled -
>         - CPU 00000000 booting -
>         - Started in Secure state -
>         - Entering Hyp mode -
>         - Setting up control registers -
>         - Turning on paging -
>         - Ready -
>         RAM: 0000000080000000 - 00000000ffffffff
>         
> I'm going to try and apply 1..7 and 9. Skipping 8, 10 and 11.

Which I've now done and pushed.

Ian.



_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel