[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [Xen-devel] [RFC PATCH V3 12/16] netback: multi-page ring support
On Tue, 2012-01-31 at 13:24 +0000, Jan Beulich wrote: > >>> On 31.01.12 at 12:09, Wei Liu <wei.liu2@xxxxxxxxxx> wrote: > > On Tue, 2012-01-31 at 09:01 +0000, Jan Beulich wrote: > >> >>> On 30.01.12 at 18:10, Wei Liu <wei.liu2@xxxxxxxxxx> wrote: > >> > On Mon, 2012-01-30 at 16:35 +0000, Jan Beulich wrote: > >> >> >>> On 30.01.12 at 15:45, Wei Liu <wei.liu2@xxxxxxxxxx> wrote: > >> >> > -int xenvif_map_frontend_rings(struct xenvif *vif, > >> >> > - grant_ref_t tx_ring_ref, > >> >> > - grant_ref_t rx_ring_ref) > >> >> > +int xenvif_map_frontend_rings(struct xen_comms *comms, > >> >> > + int domid, > >> >> > + unsigned long ring_ref[], > >> >> > + unsigned int ring_ref_count) > >> >> > { > >> >> > - void *addr; > >> >> > - struct xen_netif_tx_sring *txs; > >> >> > - struct xen_netif_rx_sring *rxs; > >> >> > - > >> >> > - int err = -ENOMEM; > >> >> > + struct gnttab_map_grant_ref op[NETBK_MAX_RING_PAGES]; > >> >> > + unsigned int i; > >> >> > + int err = 0; > >> >> > > >> >> > - err = xenbus_map_ring_valloc(xenvif_to_xenbus_device(vif), > >> >> > - tx_ring_ref, &addr); > >> >> > >> >> Any reason why you don't just extend this function (in a prerequisite > >> >> patch) rather than open coding a common utility function (twice) here, > >> >> so that other backends (blkback!) can benefit later as well. > >> >> > >> >> Jan > >> >> > >> > > >> > I'm mainly focusing on netback stuffs, so the code is slightly coupled > >> > with netback -- NETBK_MAX_RING_PAGES. > >> > > >> > To extend xenbus_map_ring_valloc and make more generic, it requires > >> > setting a global maximum page number limits on rings, I think it will > >> > require further investigation and code refactor -- which I have no time > >> > to attend to at the moment. :-/ > >> > >> Why? You can simply pass in the number of pages, there's no need > >> for a global maximum. > >> > > > > I mean the gnttab_map_gran_ref array, it is statically allocated at the > > moment. Of course we can make it dynamically allocated, but why bother > > taking the risk of allocation failure. > > There's so many other allocations, why would you worry about this > one. > IMHO, this is not a critical part of the code, so failing this one thus making all other pieces not workable is very strange. > But of course you can undo what a recent change did, and then > subsequently someone else will have to clean up again after you. > I'm just asking to follow good programming practices and write > re-usable code where potential for re-use is obvious (after all, > multi-page block interface patches have been floating around for > much longer than yours for the net interface). > I understand your concern. If the changes required will not make this series longer and involves major changes in block interface, I'm happy to refactor the xenbus interface. Wei. > Jan > _______________________________________________ Xen-devel mailing list Xen-devel@xxxxxxxxxxxxxxxxxxx http://lists.xensource.com/xen-devel
|
Lists.xenproject.org is hosted with RackSpace, monitoring our |