[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Xen-devel] libxl: error: libxl.c:2150:libxl_set_memory_target new target 0 for dom0 is below the minimum threshold
On Wed, 2011-11-23 at 13:57 +0000, Stefano Stabellini wrote:
> On Wed, 23 Nov 2011, Ian Campbell wrote:
> > > > On the other hand I'm not sure why autoballoon and dom0_mem play so
> > > > badly together. Surely if dom0_mem is used autoballon should just see
> > > > that there is plenty of free RAM in the system and not do anything?
> > >
> > > Because one of the "memory slack" paramters needed by autoballoon is
> > >
> > > totalmemory - dom0_memory_at_boot
> >
> > libxl gets dom0_memory_at_boot via the dominfo (in
> > libxl__fill_dom0_memory_info which I assume happens before any
> > potentially autoballooning) which should take dom0_mem into account,
> > doesn't it?
>
> It does, in the sense that the memory slack is trimmered to max 15% of
> total memory.
> Basically there is no way to calculate this parameter if dom0_mem is
> set, so we conservatively set it to 15%.
What I meant was that dom0_memory_at_boot comes from
XEN_SYSCTL_getdomaininfolist and is therefore the value of the dom0_mem
parameter (give or take a wiggle, I suppose), when called from
libxl__fill_dom0_memory_info (i.e. before any auto ballooning has taken
place). In other words there is a way to calculate this parameter...
Ian.
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel
|
