[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Xen-devel] Re: define BOOT_TRAMPOLINE and stack based on result of probing EBDA area by INT12



On 31/08/2011 09:47, "Lin-bao Zhang" <zhang.linbao@xxxxxxxxx> wrote:

> 1,define a variable named "EBDA_bottom".
> 2, get EBDA_bottom by above method.
> 3, stack should equals EBDA_bottom (or EBDA_bottom -1 safely)
> 4, mov     $(EBDA_bottom -1),%esp
> in most case , EBDA area is 1K,but we define 0x7c000(this is absolutely
> safe),but we will waste too much memory space.
> 
> I did test, it can work .Certainly, I am familiar with assembler code, I just
> hard code to test:mov     0x903ff , %esp thanks for your corrections , I have
> not read over all histories and stories about them, if I am wrong , I am sorry
> first.

If you actually tried to implement it you'd realise you're stuck. Because
you start off in protected mode and can't make the BIOS call, until you are
in real mode, which requires the trampoline to be set up.

 -- Keir



_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel


 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.