[Xen-devel] Re: [PATCH] watchdog, SP5100: Check if firmware has set correct value in tcobase.

[Konrad Rzeszutek Wilk <konrad.wilk@xxxxxxxxxx>]

On Wed, Mar 16, 2011 at 02:18:17PM -0700, Yinghai Lu wrote:
> 
> 
> Stefano found SP5100 TCO watchdog driver using wrong address.
> 
> [    9.148536] SP5100 TCO timer: SP5100 TCO WatchDog Timer Driver v0.01
> [    9.148628] DEBUG __ioremap_caller WARNING address=b8fe00 size=8 valid=1 
> reserved=1
> 
> and e820 said that range is RAM.
> 
> We should check if we can use that reading out. BIOS could just program wrong 
> address there.
> 
> -v2: Mike pointed out one path need one release.
> 
> Reported-by: Stefano Stabellini <stefano.stabellini@xxxxxxxxxxxxx>
> Signed-off-by:Yinghai Lu <yinghai@xxxxxxxxxx>
> Acked-by: Mike Waychison <mikew@xxxxxxxxxx>

I have no idea why it worked the first time b/c this:


> +     if (request_mem_region_exclusive(val, SP5100_WDT_MEM_MAP_SIZE, "SP5100 
> TCO")) {

is wrong. It should have been "if (!request...")..

With that, and with Stefano's patches (stefano/2.6.38-rc6-mm-fix) on top of 
2.6.39-rc0 it boots up fine.

Excerpt from the log:

[    0.000000] DEBUG find_early_table_space: _text=1000000 _end=1e33000 
pgtable_start=9fc000 pgtable_end=9fc000
[    0.000000] DEBUG find_early_table_space: _text=1000000 _end=1e33000 
pgtable_start=beba5000 pgtable_end=beba5000
[    9.064064] calling  sp5100_tco_init_module+0x0/0x1000 [sp5100_tco] @ 507
[    9.064067] SP5100 TCO timer: SP5100 TCO WatchDog Timer Driver v0.01
[    9.064180] SP5100 TCO timer: mmio address 0xb8fe00 already in use
[    9.064201] initcall sp5100_tco_init_module+0x0/0x1000 [sp5100_tco] returned 
0 after 126 usecs

Attached is the full log if folks are curious.

Attachment: d
Description: Text document

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel