Re: [Xen-devel] pv-ops dom0 doesn't boot, serial console broken

[Konrad Rzeszutek Wilk <konrad.wilk@xxxxxxxxxx>]

On Tue, Jan 26, 2010 at 05:19:38PM +0000, George Dunlap wrote:
> I did a basic make install on a fresh Debian Lenny box this morning,
> and unfortunately haven't been able to successfully boot under Xen:
> * The 2.6.27-xen-686 Lenny kernel hangs under Xen-32-PAE and under Xen-64
> * Under native, the 2.6.31.6 pv-ops kernel (pulled fresh this morning)
> boots fine, with serial console
> * Under Xen, the same kernel doesn't boot and doesn't output anything
> to the serial console, hanging after a few minutes.

What does your grub configuration entry look like?

> 
> Here's the console log of booting Linux 2.6.31.6 pv-ops (build with
> "make kernels") on a 64-bit hypervisor c/s 20858:2636e5619708 is
> attached.
> 
> Any ideas?

Dom0 boots. It probably just is outputing to nowhehere land.


_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel