RE: [Xen-devel] GPLPV 0.9.12-pre4 uploaded

["James Harper" <james.harper@xxxxxxxxxxxxxxxx>]

> On Wed, Nov 19, 2008 at 7:27 AM, James Harper
> <james.harper@xxxxxxxxxxxxxxxx> wrote:
> > I've just uploaded 0.9.12-pre4 to
http://www.meadowcourt.org/downloads
> >
> > Fixes/updates since 0.9.12-pre3:
> > . rolled back IRQ restriction which would prevent the drivers from
> > starting if the pci device wanted to use an IRQ < 16
> 
> Yup, this fixed my issue.  Things are looking good now.  This is just
> my virtual XP workstation for Outlook and a couple of other programs,
> but so far I'd say it 'feels' better.  It's obvious the network driver
> is configured, as it's all that shows up in the network applet now.  I
> see the Xen Block Device Driver in the scsi section of the device
> manager, but is there any clear way to verify the PV block device is
> active?  Powershell certainly seemed to load 4-6 seconds faster.
> 
> In the future, would I just install new versions over the top of the
> current version?

Yes. That's all I do.

Thanks

James

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel