Re: [Xen-devel] No console with xen-3.2

["Chuck Short" <zulcss@xxxxxxxxx>]

correct


On Nov 13, 2007 10:54 AM, Stefan Berger <stefanb@xxxxxxxxxx> wrote:
>
> Are you using the tip of the tree? Could it be a crash? I see it crashing
> (tip) and only the cursor blinking in the upper left corner.
>
>    Stefan
>
> xen-devel-bounces@xxxxxxxxxxxxxxxxxxx wrote on 11/13/2007 10:18:53 AM:
>
>
>
>  > No output at all.
>  >
>  > On Nov 13, 2007 10:10 AM, Keir Fraser <Keir.Fraser@xxxxxxxxxxxx> wrote:
>  > > Do you mean you cannot type input at the vga console, or do you mean
> there
>  > > is no output at all? Does output from Xen appear, but not from dom0?
>  > >
>  > >  -- Keir
>  > >
>  > >
>  > > On 13/11/07 13:40, "Chuck Short" <zulcss@xxxxxxxxx> wrote:
>  > >
>  > > > Hi,
>  > > >
>  > > > I installed Xen-3.2 last night and setup the grub.conf and kernel as
>  > > > usual. However, when I rebooted I did not get an console input when
>  > > > booting the dom0. I tried adding the console=vga to my grub.conf as
>  > > > shown below:
>  > > >
>  > > > title xen-3.2
>  > > > root (hd0,0)
>  > > > kernel /boot/xen-3.2.gz console=vga
>  > > > module  /boot/vmlinuz-2.6.18.8
>  > > > root=UUID=7373696f-c367-4a6a-b198-17e593508cc8 ro console=tty0
>  > > > module /boot/xen-2.6.18
>  > > > quiet
>  > > >
>  > > > I am not sure where to go from here.
>  > > >
>  > > > Thanks
>  > > > chuck
>  > > >
>  > > > _______________________________________________
>  > > > Xen-devel mailing list
>  > > > Xen-devel@xxxxxxxxxxxxxxxxxxx
>  > > > http://lists.xensource.com/xen-devel
>  > >
>  > >
>  > >
>  >
>  > _______________________________________________
>  > Xen-devel mailing list
>  > Xen-devel@xxxxxxxxxxxxxxxxxxx
>  > http://lists.xensource.com/xen-devel
>

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel