[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [Filtered!] [Xen-devel] Networking problems with xen3
On Sun, Nov 06, 2005 at 08:57:18PM -0000, Ian Pratt wrote: > > Everything looks fine during the boot, the network device is > > detected, and the distro scripts bring it up as normal, going > > as far as displaying a link up message in the log. However, > > if I try and do something over the network, things > > immediately go wrong. > > The network card is trying to use irq3, which is normally reserved for > COM2. I'm wandering whether this is causing problems. > > Can you try configuring the card for a different interrupt line? > > Ian The bios on this board doesn't give any direct control over interrupt lines. However, by playing about with some of the configuration options, I was able to shift it over to irq5, and then irq10. Both failed in exactly the same manner. J -- Jody Belka knew (at) pimb (dot) org _______________________________________________ Xen-devel mailing list Xen-devel@xxxxxxxxxxxxxxxxxxx http://lists.xensource.com/xen-devel
|
![]() |
Lists.xenproject.org is hosted with RackSpace, monitoring our |