Re: [Xen-devel] DMA trouble with current xen-sparse

[Daniel Veillard <veillard@xxxxxxxxxx>]

On Wed, Nov 02, 2005 at 10:36:17AM -0500, Stephen Tweedie wrote:
> Hi,
> 
> On Wed, Nov 02, 2005 at 03:32:58PM -0000, Ian Pratt wrote:
>  
> > Does your card support TSO? What revision e1000 is it?
> 
> Yes, and I'll check on Friday once I'm back from travelling (but it is
> a very recent box.)

  I am seeing the exact same problem with my Dell Latitude D800 laptop using
Ethernet controller: Broadcom Corporation NetXtreme BCM5705M Gigabit Ethernet 
(rev 01)
This is a relatively common and not so recent configuration.

> > Please can you try turning it off with: 
> >   ethtool -K eth0 tso off
> 
> I already tried that and it did not help.  I've also tried both gcc32
> and gcc4 with no success.

[root@localhost ~]# ethtool -K eth0 tso off
Cannot set device tcp segmentation offload settings: Operation not supported

  too bad ...
  with 'swiotlb=force swiotlb=8m' kernel parameters the box is stable,
without it very basic network access can crash it (say 'locate lib' over ssh)
and then the whole system reboots.

  100% reproductible for me, and without crazy hardware :-)

   Hope this helps,

Daniel

-- 
Daniel Veillard      | Red Hat http://redhat.com/
veillard@xxxxxxxxxx  | libxml GNOME XML XSLT toolkit  http://xmlsoft.org/
http://veillard.com/ | Rpmfind RPM search engine http://rpmfind.net/

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel