[Xen-devel] Xen on Pentium III issues

[Sean Dague <sean@xxxxxxxxx>]

I'm noticing that the same configuration of Xen DomUs that works on a 2x2.4
Ghz P4 breaks a lot on a 2x700 Mhz Pentium III (though it used to work ~
early Sept).  By breaks a lot I mean some DomUs can never start, even by
hand.

Is anyone else seeing this?  I know that in general using a PIII for
development is tough, as it means lots of slow compiles, but I've got access
to lots of that hardware, so it has made a convenient test platform (at
least up until it not working at all 2 months ago).

Other comments would be welcomed before I dig too deep here.  This is my
last xm-test run
(http://xmtest.dague.org/cgi-bin/display?view=single&testid=103), though
I'll also rerun that today to see if anything got better in the last 2
weeks.

        -Sean

-- 
__________________________________________________________________

Sean Dague                                       Mid-Hudson Valley
sean at dague dot net                            Linux Users Group
http://dague.net                                 http://mhvlug.org

There is no silver bullet.  Plus, werewolves make better neighbors
than zombies, and they tend to keep the vampire population down.
__________________________________________________________________

Attachment: pgpCurG41C2iF.pgp
Description: PGP signature

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel