Re: [Xen-devel] building xen for x86_64

[Alexander Charbonnet <alexander@xxxxxxxxxxxxxx>]

Just make sure that "Processor Type" is set to x86_64, not x86, in the Xen 
menu.


On Monday 17 October 2005 03:21 pm, David F Barrera wrote:
> On Mon, 2005-10-17 at 13:09 -0700, Pat Huntington wrote:
> > Are there any special options I need to pass to make
> > to get Xen to build correctly for x86_64 or will it
> > automagically work? I ask because I'm getting 'DOM0
> > image is not a Xen-compatible Elf image' on bootup
> > which I guess means I'm probably doing something wrong
> > in the compile. I'm using a 64 bit toolchain, build
> > enviroment is FC4 using GCC version 4.0.1, binutils
> > version 2.1 so I'm guessing it's not my tools. Xen is
> > compiling but I get that Elf message on reboot. I
> > figure it's because I'm not compiling for 64 bit
> > correctly.
> >
> > Do I have to pass XEN_TARGET_ARCH=x86_64 or something
> > like that?
>
> It is automatic. I build it everyday on x86_64 by using 'make world', as
> I do on x86.
>
> > Sorry if this is documented somewhere, I tried in vain
> > to find it but to no avail.
> >
> > Thanks!
> >
> >
> >
> >
> > __________________________________
> > Yahoo! Mail - PC Magazine Editors' Choice 2005
> > http://mail.yahoo.com
> >
> > _______________________________________________
> > Xen-devel mailing list
> > Xen-devel@xxxxxxxxxxxxxxxxxxx
> > http://lists.xensource.com/xen-devel

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel