Re: [Xen-devel] Adaptec 7892 Not Showing

[David Isaac Wolinsky <davidiw@xxxxxxx>]

> > I am trying to boot Xen on a Adaptec 7892 SCSI controller and 
> > it isn't even going into the check routines for the disk!  
> > (Ie, no disks are found and I can't boot into Xen...)...  It 
> > works fine on FC3 and the drivers are compiled into the 
> > kernel (I tried both new and old...).  The machine is an IBM 
> > eSeries 330.
> >    
> Are you using the -xen kernel? I doubt the -xen0 kernel has a driver
> compiled in for that card.
>
> Are you actually seeing the startup messages for the driver?
>
> [The -xen kernel has a wide variety of modules, but you'll need to build
> an initrd]
>
> Ian
>
>  
I compiled support directly into the kernel for the AIC7xxx driver, and 
it supposedly has support for the 7892.  No I'm not seeing start-up 
messages, just that the "SCSI subsystem initialized".
David

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel