RE: [Xen-devel] xen dom0 failed to boot up if compiled with "framepointer" enabled

[Xin Zhao <zhaoxin@xxxxxxxxxxxxxx>]

Yes. I did. the frame pointer works with domU, but not dom0. I will
probably try again.

Thanks,

Xin


On Mon, 3 Oct 2005, Ian Pratt wrote:

> > I need to compile xen0 with frame pointer switch on. But the
> > compiled kernel cannot boot up with panic message.
> >
> > Any thought about this?
>
> I've done this within the last month without problems. Did you do a make
> ARCH=xen clean beforehand?
>
> Ian
>
> _______________________________________________
> Xen-devel mailing list
> Xen-devel@xxxxxxxxxxxxxxxxxxx
> http://lists.xensource.com/xen-devel
>

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel