Re: [Xen-devel] ethool for e1000

[Nivedita Singhvi <niv@xxxxxxxxxx>]

Ted Kaczmarek wrote:
> I recently noticed that after starting xend ethtool no longer work for
> my e1000 card. In my 2.X box which is a P4, ethtool is working after
> xend start. Same version of e1000 on both boxes. 
>
> The unstable box is a
> Tyan 2462 SMP, FC4 dom0
>
>
> The 2.X box is
> Dell P330 UP, Centos 4.1 domO
>  
> Until xend start ethtool is fine, in both setups I am using the e1000 as
> eth0.
Doesn't even work on peth0? Once xend starts, the phydical eth0
interface is renamed to peth0.

thanks,
Nivedita



_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel