Re: [Xen-devel] Re: hda: lost interrupt

["Rich Persaud" <rich@xxxxxxxxxxxxx>]

I recall that the K7S5A motherboard has a unique, dedicated bus for the onboard IDE controller (and NIC, if present). 

Is that also true for the K7S8X?

How far does the dom0 boot proceed before stopping?

As a test, can you disable the onboard IDE controller and boot the Xen LiveCD off a drive on the Promise PCI controller?

Rich

-----Original Message-----
From: Fred Richards <tech@xxxxxxxxxxxxx>
Date: Fri, 15 Apr 2005 15:38:56
To:xen-devel@xxxxxxxxxxxxxxxxxxx
Subject: [Xen-devel] Re: hda: lost 


joe <toby4u <at> freenet.de> writes:

>
> hi i am a complete newbie to xen,
> and i have still a problem with hda(hdc): lost interrupt coming from the
> 2.6.10-xen0 kernel on an asrock k7s8x board with an additional promise
> 100 controller(doesn't get recognized anyway) an amd athlon 2400+ and
> 512 mb ram.
>
> an ideas?
>
> regards
> toby
>


Ok, now that's odd.  I'm having the same problem, and much of my hardware is
similar.  I have an ECS K7S5A motherboard, AMD Athlon 2400+ and a promise
Ultra100TX2 controller.  Note, however, the Promise card is not the one having
the issue.  In other words, my error is hdc: lost interrupt ... my primary
controller has 2 drives (hda, hdb) my second controller two dvdrom devices (hdc,
hdd) and one storage drive on the promise card (hde).  If I disable hdc, the
error changes to hdd lost interrupt.

I've tried even the LiveCD 2.0.5 version.  It works perfect on other hardware,
but has an issue booting Domain 0.


_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel