[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [Xen-devel] xen 2.0.1, 2.4.27, 2.6.9, non-bridge


  • To: "Adam Heath" <doogie@xxxxxxxxxxxxx>
  • From: "Ian Pratt" <m+Ian.Pratt@xxxxxxxxxxxx>
  • Date: Wed, 5 Jan 2005 01:12:26 -0000
  • Cc: <xen-devel@xxxxxxxxxxxxxxxxxxxxx>
  • Delivery-date: Wed, 05 Jan 2005 01:21:03 +0000
  • List-id: List for Xen developers <xen-devel.lists.sourceforge.net>
  • Thread-index: AcTyv4F4EsdJmX3ySWK4M3Pp6FxoYQAAZJZg
  • Thread-topic: [Xen-devel] xen 2.0.1, 2.4.27, 2.6.9, non-bridge

> Note, that one must *always* specify the bridge parameter in 
> the config, and
> you can't specifiy additional parameters to be passed to this 
> script.  That's
> why I was forced to use the $domain.

Can't you replace the bridge-name parameter with the hostname or IP
address of the domain? (I haven't tried this). Adding a means of passing
extra parameters shouldn't be too hard anyhow.
 
> If one wanted to use a dhcp relay on dom0, then the mac 
> addresses of the
> vifX.X interfaces *must* be unique.  With the above setup, 
> that is not a
> requirement.

Do you use DHCP to assign (static) addresses in your configuration, or
configure the address on the domain's command line? 

Assignment of dynamic DHCP addresses is always going to be messy, but
fortunately its not a very useful thing to support. 

Ian


-------------------------------------------------------
The SF.Net email is sponsored by: Beat the post-holiday blues
Get a FREE limited edition SourceForge.net t-shirt from ThinkGeek.
It's fun and FREE -- well, almost....http://www.thinkgeek.com/sfshirt
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.sourceforge.net/lists/listinfo/xen-devel


 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.