Re: [Xen-devel] Troubles with 2.6-booting and xend

[Keir Fraser <Keir.Fraser@xxxxxxxxxxxx>]

xend should configure the bridge interface with eth0's IP address, and
update your routing table appropriately -- all local traffic is
delievered via the bridge and not eth0.

 -- Keir

> Shoot, have not been following this thread. I just noticed it. 
> 
> I am seeing the following, not sure if it is related. 
> 
> On the 2.0 and 2.0-testing, if I start xend, it sets up xen-br0. 
> 
> Once I start up a domain, it sets up the vifx.0. domx (where x is a number
> > 0, of course) is configured (by the domx) as ip 172.16.233.201; dom0
> has 10.128.207.119 on eth0. 
> 
> I can't get any networking from domx to dom0 to work at all unless I do 
> this:
> ifconfif xen-br0 down
> brctl delbr xen-br0
> 
> ifconfig vifx.0 172.16.233.200
> 
> Yet, on vmware, this problem does not happen. 
> 
> I'm still looking but I'm not sure what's wrong here.
> 
> ron
> 
> 
> -------------------------------------------------------
> SF email is sponsored by - The IT Product Guide
> Read honest & candid reviews on hundreds of IT Products from real users.
> Discover which products truly live up to the hype. Start reading now. 
> http://productguide.itmanagersjournal.com/
> _______________________________________________
> Xen-devel mailing list
> Xen-devel@xxxxxxxxxxxxxxxxxxxxx
> https://lists.sourceforge.net/lists/listinfo/xen-devel



-------------------------------------------------------
SF email is sponsored by - The IT Product Guide
Read honest & candid reviews on hundreds of IT Products from real users.
Discover which products truly live up to the hype. Start reading now. 
http://productguide.itmanagersjournal.com/
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.sourceforge.net/lists/listinfo/xen-devel