Re: [Xen-devel] panic in e100_exec_cb()

[Keir Fraser <Keir.Fraser@xxxxxxxxxxxx>]

> I do see this in the syslog, which appears strange to me:
> 
> Xen1 kernel: Symbols match kernel version 2.6.8.
> Xen1 kernel: No module symbols loaded - kernel modules not enabled.

You built a kernel with no module support?

> Also:
> 
> Xen1 kernel: Kernel command line: /boot/vmlinuz-2.6.8.1-xen0 root=/dev/sda1 
> ro 
> console=tty0 console=ttyS0
> Xen1 kernel: Unknown boot option `/boot/vmlinuz-2.6.8.1-xen0' : ignoring

That looks like a bug in our handling of the command line. We should
strip the kernel-image name.

> By grub boot instructions are: 
> 
> kernel /boot/xen.gz dom0_mem=131072 com21=115200,8n1
> module /boot/vmlinuz-2.6.8.1-xen0 root=/dev/sda1 ro console=tty0 console=ttyS0
> 
> Is this not correct for the 2.6.x kernels?

In general, handling of two 'console=' commands is a bit suspect --
this is true of vanilla Linux as well. IT's not always obvious where
your boot messages will go after init starts. :-)

Apart from that it looks fine.

 -- Keir


-------------------------------------------------------
This SF.Net email is sponsored by: YOU BE THE JUDGE. Be one of 170
Project Admins to receive an Apple iPod Mini FREE for your judgement on
who ports your project to Linux PPC the best. Sponsored by IBM.
Deadline: Sept. 24. Go here: http://sf.net/ppc_contest.php
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.sourceforge.net/lists/listinfo/xen-devel