Re: [XenARM] [Xen-devel] Xen on OMAP5432

[Ian Campbell <Ian.Campbell@xxxxxxxxxx>]

On Wed, 2013-06-26 at 15:31 +0800, Chen Baozi wrote:
> Hi Ian,
> On Jun 25, 2013, at 11:12 PM, Ian Campbell <Ian.Campbell@xxxxxxxxxx> wrote:
> 
> > On Tue, 2013-06-25 at 16:47 +0800, Chen Baozi wrote:
> >> Hi all,
> >> 
> >> I've got an OMAP5432 uEVM development board and wondered if it is already 
> >> supported by Xen?
> > 
> > Not by the Xen w/ hardware extensions port (i.e.
> > http://wiki.xen.org/wiki/Xen_ARM_with_Virtualization_Extensions). I
> > can't speak for the PV port.
> > 
> > If the hardware has the appropriate virtualisation support then porting
> > to a new platform isn't all that troublesome, if you've got a working
> > upstream Linux kernel with DTB support to use as dom0.
> Thanks.
> 
> TI ships a 3.8.4 kernel for OMAP5432 uEVM. I think it may be new enough for a 
> dom0?

I think so, initial support was in 3.7 IIRC and 3.8 had most of what is
needed to get started. You likely just need to recompile it with
CONFIG_XEN enabled.

Ian.



_______________________________________________
Xen-arm mailing list
Xen-arm@xxxxxxxxxxxxx
http://lists.xen.org/cgi-bin/mailman/listinfo/xen-arm