Re: [XenARM] How to boot the xen up in Uboot?

[Jae-Min Ryu <jm77.ryu@xxxxxxxxxxx>]

Hi,

Let me know about your H/W platform spec, especially physical memory map.
At the momenent, xen-arm was only focused on the Tegra harmony board. 

Thanks,


Subject: [XenARM] How to boot the xen up in Uboot?
Message-ID: <3ABABE07-D209-4A94-A6A6-B251575CDDF0@xxxxxxxxx>
Content-Type: text/plain; charset="us-ascii"

Hi all,

Recently i'm trying to boot xen on Trim Slice, which is powered by Tegra2.
The source code is cloned from jaeminryu's GIT Repo. 

I modify the position of toolchain_prefix, then use the command:

make install-xen

i get this following three files.

-rwxr-xr-x  1 wangzhihao root  431728 2012-03-06 12:05 xen*
-rw-r--r--  1 wangzhihao root  145294 2012-03-06 12:05 xen.gz
-rwxr-xr-x  1 wangzhihao root 1711910 2012-03-06 12:05 xen-syms*

The user guide[ Secure_Xen_on_ARM_User_Guide_v1_1.pdf ] tells me to boot system 
like this in Uboot:

set ipaddr 10.30.0.13
set serverip 10.30.0.21
tftp 0xc0008000 xen
go 0xc0008000

But it stuck and give nothing info, while I expect these info:

[XEN] 
[XEN]Xen/ARM virtual machine monitor for ARM architecture 
[XEN] Copyright (C) 2007 Samsung Electronics Co, Ltd. All Rights Reserved. 
[XEN] Using scheduler: Borrowed Virtual Time (bvt)
[XEN] *** LOADING DOMAIN : 0 *** 
[XEN] Physical Memory Arrangement: c0200000->c2000000

I think it should give the red part even if i don't specify the dom0's position.

Can you give me some tips to get it boot up ?

Best Regards
Wang zhihao
_______________________________________________
Xen-arm mailing list
Xen-arm@xxxxxxxxxxxxx
http://lists.xen.org/cgi-bin/mailman/listinfo/xen-arm