Re: [Xen-API] PCI passthrough - XCP vs XenServer

[Dave Scott <Dave.Scott@xxxxxxxxxxxxx>]

Hi,

> > your command should look like this:
> >  # xe vm-param-set other-config:pci=0/0000:05:00.0,0/0000:05:00.2
> > uuid=7a1f3bcd-4b2d-4c10-5aa4-4238a48f011d
> 
> Thanks Marien. Unfortunately, even when I run the command like that I only
> see 1 of the 2 when I run lspci on my VM, so for some reason it's not getting
> passed through properly :( Perhaps it's something to do with this particular
> card, I don't know, but I'm a little stuck now.

IIRC there's been some confusion in the past about what the first number ("0/") 
means in the PCI passthrough syntax. It's possible that some of the code is 
interpreting it as a virtual slot number of a plug ordering (or both). Try 
using the string

0/0000:05:00.0,1/0000:05:00.2

Just in case there's a bug in the reboot code, I recommend powering off the VM 
and then starting it, rather than rebooting.

Cheers,
Dave

_______________________________________________
Xen-api mailing list
Xen-api@xxxxxxxxxxxxx
http://lists.xen.org/cgi-bin/mailman/listinfo/xen-api